1 December 2019 in Géotechnique Letters
In the mining industry, waste dumps are earthen structures typically built by loose waste tipping. They may reach heights of hundreds of metres and undergo large deformations. For this reason, their stability design is based on the steady-state shear strength of the waste material. Waste materials are widely graded and may contain particles of up to metric order. Particle shape depends on the pattern of dissecting discontinuities at the source rock mass and the relation between the size of the fragments and discontinuity spacing. The shear strength of this material is determined in the laboratory using scaled samples with altered particle-size distribution (PSD). However, altering the PSD is known to impact shear strength, and this impact is poorly studied. The representativeness of laboratory parameters obtained from scaled samples is thus arguable. Discrete-element simulations are used here to investigate steady-state shear strength changes with the alteration of the PSD when particle size and shape are correlated. It is observed that shear strength changes result from the variation of the particle shapes induced by the alteration of the PSD. Consequently, identifying size−shape correlations and their potential impact on shear strength is of paramount importance when scaling materials for laboratory testing.
1 June 2015 in Computers and Geotechnics
19 February 2026 in Computers and Geotechnics
MCManuel Cárdenas-Barrantes
Manuel Cárdenas-Barrantes
+1
21 September 2026 in Physical Review E
The mechanical behavior of granular media is strongly influenced by particle geometry, including both size and shape. While critical-state shear strength is widely reported to be insensitive to particle size distribution (PSD) in assemblies of grains sharing a common shape, grain shape itself has a strong impact on strength, with angular particles generally producing higher resistance than rounded ones. Many natural and industrial granular materials, however, combine broad size distributions with significant variability in particle shape, often correlated with particle size. Whether the classical PSD-insensitivity of shear strength still holds when particle shape varies across size classes remains largely unexplored. Here, we present a systematic experimental investigation of sheared granular assemblies composed of injection-molded particles with controlled sizes and shapes. Mono, bi, and polyshaped mixtures built from six characteristic grain geometries are tested under triaxial compression. We show that the classical PSD-insensitivity of critical-state shear strength breaks down when particle shape becomes size dependent. For a given PSD, assemblies with angular small grains and rounded large grains exhibit significantly higher shear strength than those with the opposite size-shape arrangement. This behavior persists over a wide range of PSDs and can be explained by enhanced geometrical interlocking promoted by angular small particles filling the voids between larger grains.