Empirical mode decomposition splits a signal into several intrinsic mode functions (IMF). An algorithm for the automatic selection of the modes containing the signal of interest was recently proposed. This algorithm is based on statistical analysis describing the noise repartition between IMFs. This algorithm uses an estimate of the signal noise content from the energy of the first IMF, which is supposed to contain a specific part of the total noise and to contain noise only. Mode mixing can give rise to an over-estimation of the noise in the signal. This can lead to more IMFs to be considered as containing only noise and to be erroneously discarded before reconstruction. We propose to use mode mixing detection based on a stationarity test applied to the first IMF. In case of mode mixing, we propose to correct the noise estimation by extracting from the first IMF the part corresponding to the signal of interest. The results obtained with synthetic signals as well as with real mechanical and biomedical signals demonstrate a good performance of the approach proposed here. The first two modes do lose some of their IMF properties in the process. We offer some comments on how these properties can be recovered if needed.
3 June 2010 in EURASIP Journal on Advances in Signal Processing
This paper describes the use of the Morlet wavelet transform to investigate the difference in the time-frequency plane between uterine EMG signals recorded simultaneously on two different sites on women's abdomen, both during pregnancy and in labor. The methods used are wavelet transform, cross wavelet transform, phase/amplitude correlation, and phase synchronization. We computed the linear relationship and phase synchronization between uterine signals measured during the same contractions at two different sites on data obtained from women during pregnancy and labor. The results show that the Morlet wavelet transform can successfully analyze and quantify the relationship between uterine electrical activities at different sites and could be employed to investigate the evolution of uterine contraction from pregnancy to labor.
26 May 2025 in IEEE Transactions on Instrumentation and Measurement
Magnetic localization techniques present some interests for micro robotics applications using smart surfaces due to their inherent advantages, such as integration ability or low cost. However, at microscale, these methods often encounter challenges to perform with high precision in real scenario, because of the limitation of calculation algorithms (numerical stability, convergence, approximation methods) and the impact of measurement uncertainties (misalignment, sensor performance, etc.). This paper presents a new 2D magnetic localization method based on a 3D Hall effect sensor array system, in order to localize a cubic magnet. The proposed approach combines an efficient numerical resolution algorithm (Newton-Raphson) with precise analytical models of the magnetic field of the magnet to brave these measurement uncertainties and to achieve high-resolution 2D magnetic localization. Through performance assessments from simulation calculations and experimentations, the operation and efficiency of the proposed method is demonstrated. Results indicate good performance of the Newton-Raphson method with micrometric accuracy, even when there are measurement uncertainties in real scenario. Experimental test realized with a prototype of 3D Hall effect sensor array confirms the efficiency of the 2D magnetic localization with an averaged 12.73 μm localization error. A comparative analysis shows that this new magnetic localization method is well placed in the hierarchy of existing methods, that estimate the 2D position of a magnet by using a Hall effect sensor array system.
17 June 2019 in IEEE/ASME Transactions on Mechatronics