Heat Transfer Laboratory - LabTC, Institute of Mechanical Engineering - IEM, Federal University of Itajubá - UNIFEI, Campus Professor José Rodrigues Seabra, BPS Avenue 1303, Itajubá, MG, Brazil
Auto-generated profile, based on publicly available information
Mariana de Melo Antunes
Heat Transfer Laboratory - LabTC, Institute of Mechanical Engineering - IEM, Federal University of Itajubá - UNIFEI, Campus Professor José Rodrigues Seabra, BPS Avenue 1303, Itajubá, MG, Brazil
This paper presents an experimental approach for simultaneously identifying the temperature-dependent thermal conductivity ( k ) and specific heat ( cp ) of 304 austenitic stainless steel (ASS) using complementary transient experiments and metaheuristics. Inverse thermal analysis was based on two heat conducting solids with different geometries. In estimation problems in general, one seeks to obtain as much sensitive data as possible using as few sensors as possible. Single thermocouple data were collected for each thermal model. An objective function fitting these complementary measurements to the corresponding numerical temperatures was minimized using the Lichtenberg algorithm. This metaheuristic algorithm takes advantage of more sensitive information provided by using complementary data, enabling for an accurate inverse solution, even when dealing with wide search ranges. The proposed technique provides a cost-effective and robust property estimation from tests conducted at room temperature. Single-step estimation occurred throughout the whole temperature domain to determine the parameters for linear functions representing the temperature dependence of k and cp . The obtained lines agreed well with curves from the literature. The 95% confidence bounds for the parameters of interest indicated deviations below ± 8.5%. Error analysis considering numerical and experimental processes showed an uncertainty close to ± 3%, applied to all estimated parameters.
9 December 2025 in International Journal of Hyperthermia
This study proposes analytical and hybrid models for fast and accurate temperature field reconstruction in microwave ablation (MWA), laser interstitial thermal therapy (LITT), and radiofrequency ablation (RFA), aiming at future real-time clinical use. The proposed approach combines spatial variable transformation and the Laplace transform for time-dependent terms, with finite difference techniques. A 1 mm isotropic grid represents the voxel network. To ensure accurate temperature representation, voxel-averaged temperatures are computed by integrating the solution of the bioheat equation, under spherical symmetry, over voxel bounds. To approximate the elongated ablation zone, the central circumference of the spherical model is repeated and incorporated into a hemisphere-based geometry. Simulated temperature fields are aligned with experimental MRI data using Advanced Normalization Tools (ANTs). All experiments were conducted ex vivo: MWA in bovine liver, and LITT and RFA in agar phantoms. Regions of interest (ROIs) include voxels with significant thermal variation. Heat source parameters are estimated by minimizing the quadratic difference between simulated and MRI-derived temperatures via a spatiotemporal objective function. Across all modalities, over 83-98% of voxels presented RMSE 1°C, with few exceeding 10°C. LITT showed the best overall agreement. Total simulation and alignment per repetitions required under 0.3 s, significantly below MRI repetition time, enabling potential intraoperative use. Although approximate and not yet ready for in vivo clinical application, the proposed models offer fast, voxel-level temperature reconstructions. Their computational efficiency supports further development toward real-time monitoring and procedural adjustment during thermal ablation.
This paper presents an experimental inverse approach to simultaneously estimate the temperature-dependent thermal properties of AISI 316 stainless steel. The heat flux conducted to the sample was corrected by using a transducer, evaluating contact resistance at microscopic level, and performing experiments under vacuum. Estimates were severely biased when heat flux correction was not applied. Metaheuristics were used to enlarge the search space, which can cover the thermal properties of all known metallic materials, thereby taking advantage of better thermal modeling adequacy. The estimation reliability was shown by comparison with literature data, statistical significance, uncertainty analysis, and inverse heat flux retrieval.