17 January 2019 in Journal of Manufacturing Science and Engineering
The honeycomb sandwich structure has been widely used in the aerospace industry due to its high specific strength and stiffness. However, the machining defects of the aluminum honeycomb core (AHC) have become the key factor that restricts its application. In this paper, the defects' characteristics including the formation mechanism, distribution characteristic, and cutting process of honeycomb cell walls during AHC milling process were experimentally investigated. Furthermore, using normalized Cockcroft and Latham ductile fracture criterion and Johnson–Cook (JC) constitutive model, the numerical simulation of the AHC machining process was conducted concerning the entrance angle. It is indicated that six categories of milling defects are obtained and the quantity as well as distribution regularity of AHC milling defects are determined by the double effects of both the entrance angle and cutting force. Most of the surface defects of honeycomb materials were found concentrated in three regions, named by zones I–III, in which extruding, shear, and tensile deformation was mainly generated, respectively. Besides, the finite element simulation results also agree well with the experimental findings. Finally, a novel optimization method to avoid defects in the aforementioned regions by controlling the entrance angle of all the honeycomb walls during the cutting process was proposed in this paper. Meanwhile, the optimal control equations of the entrance angle for all cell walls were derived. This method was verified by milling experiments at last and the results showed that the optimization effect was obvious since the quality of the machined surface was greatly improved.
3 February 2017 in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
Accurate simulation about the grinding temperature distribution helps to decrease the thermal damage and microcracks during the grinding process. In this article, the grinding heat transfer process of form grinding was analyzed and a temperature distribution model was derived in form grinding of 9Mn2V thread gauge. Considering the characteristics of form grinding, the temperature rise of the intersection region can be affected by two kinds of heat sources, and the impact between the two heat sources has been investigated. Also, the influence of the grinding depth on the temperature rise was analyzed. Depending on the analysis, an improved heat partition model has been derived, which is based on single-grain energy partition model. A series of experiments were carried out to investigate the grinding performance of 9Mn2V. The grinding force was obtained, the specific grinding energy was discussed, and the experimental temperature was measured by infrared imager. It is shown that the experiment results correspond well to the theoretical temperature calculated by the prediction model. This temperature model can be used to optimize the grinding conditions and the critical depth in form grinding of 9Mn2V thread gauge.