11 December 2020 in IEEE Transactions on Geoscience and Remote Sensing
The Temporal Experiment for Storms and Tropical Systems Technology Demonstration (TEMPEST-D) instrument is a five-frequency millimeter-wave radiometer operating from 87 to 181 GHz. The cross-track scanning radiometer has been operating on a 6U CubeSat in low Earth orbit since September 5, 2018. The direct-detection architecture of the radiometer reduces its mass and power consumption by eliminating the need for a local oscillator and mixer, also reducing system complexity. The instrument includes a scanning reflector and ambient calibration target. The reflector rotates continuously to scan the antenna beams in the cross-track direction, first across the blackbody calibration target, then toward the Earth over the full range of incidence angles, and finally to cosmic microwave background radiation at 2.73 K. This enables precision end-to-end calibration of the millimeter-wave receivers during every 2-s scan period. The TEMPEST-D millimeter-wave radiometers are based on 35-nm indium phosphide (InP) high-electron-mobility transistor (HEMT) low-noise amplifiers. This article describes the instrument and its characterization prior to launch.
9 September 2020 in IEEE Transactions on Geoscience and Remote Sensing
Temporal Experiment for Storms and Tropical Systems--Demonstration (TEMPEST-D) is a 6U CubeSat satellite with a cross-track scanning millimeter-wave radiometer measuring at five frequencies from 87 to 181 GHz. It employs a direct-detection architecture with InP HEMT monolithic microwave integrated circuit (MMIC) low-noise amplifiers and related new technologies. An end-to-end two-point external calibration is performed every 2-s rotation of the scanning mirror, based on observations of the cosmic microwave background and an internal blackbody calibration target, with three thermistors to monitor the target physical temperature. Corrections for antenna pattern effects and cross-scan biases based on prelaunch measured values were updated using data from an on-orbit calibration pitch maneuver. Validation of the observed brightness temperatures (TB) is performed by comparing to coincident nonprecipitating ocean observations from five well-calibrated on-orbit instruments, including Global Precipitation Measurement (GPM) mission Microwave Imager (GMI) and four Microwave Humidity Sounder (MHS) sensors on board NOAA-19, MetOp-A, MetOp-B, and MetOp-C satellites. Absolute calibration accuracy is within 1 K for all channels, well within the 4-K requirement. Calibration precision, or stability over time, is within 0.6 K for all channels, also well within the 2-K requirement. The intrinsic noise of TEMPEST-D is lower than MHS, resulting in similar on-orbit noise equivalent differential temperatures (NEDTs), even though TEMPEST-D has a much shorter integration time of 5 ms as compared to 18 ms for MHS. As a result, although the TEMPEST-D radiometer is substantially smaller, lower power, and lower cost than similar current operational radiometers, it has comparable or better performance in terms of instrument noise, calibration accuracy, and calibration stability or precision.