28 August 2023 in Remote Sensing in Ecology and Conservation
Camera traps have become important tools for the monitoring of animal populations. However, the study‐specific estimation of animal detection probabilities is key if unbiased abundance estimates of unmarked species are to be obtained. Since this process can be very time‐consuming, we developed the first semi‐automated workflow for animals of any size and shape to estimate detection probabilities and population densities. In order to obtain observation distances, a deep learning algorithm is used to create relative depth images that are calibrated with a small set of reference photos for each location, with distances then extracted for animals automatically detected by MegaDetector 4.0. Animal detection by MegaDetector was generally independent of the distance to the camera trap for 10 animal species at two different study sites. If an animal was detected both manually and automatically, the difference in the distance estimates was often minimal at a distance about 4 m from the camera trap. The difference increased approximately linearly for larger distances. Nonetheless, population density estimates based on manual and semi‐automated camera trap distance sampling workflows did not differ significantly. Our results show that a readily available software for semi‐automated distance estimation can reliably be used within a camera trap distance sampling workflow, reducing the time required for data processing, by >13‐fold. This greatly improves the accessibility of camera trap distance sampling for wildlife research and management.
18 May 2022 in Frontiers in Ecology and Evolution
Density is a key trait of populations and an essential parameter in ecological research, wildlife conservation and management. Several models have been developed to estimate population density based on camera trapping data, including the random encounter model (REM) and camera trap distance sampling (CTDS). Both models need to account for variation in animal behavior that depends, for example, on the species and sex of the animals along with temporally varying environmental factors. We examined whether the density estimates of REM and CTDS can be improved for Europe’s most numerous deer species, by adjusting the behavior-related model parameters per species and accounting for differences in movement speeds between sexes, seasons, and years. Our results showed that bias through inadequate consideration of animal behavior was exceeded by the uncertainty of the density estimates, which was mainly influenced by variation in the number of independent observations between camera trap locations. The neglection of seasonal and annual differences in movement speed estimates for REM overestimated densities of red deer in autumn and spring by ca. 14%. This GPS telemetry-derived parameter was found to be most problematic for roe deer females in summer and spring when movement behavior was characterized by small-scale displacements relative to the intervals of the GPS fixes. In CTDS, density estimates of red deer improved foremost through the consideration of behavioral reactions to the camera traps (avoiding bias of max. 19%), while species-specific delays between photos had a larger effect for roe deer. In general, the applicability of both REM and CTDS would profit profoundly from improvements in their precision along with the reduction in bias achieved by exploiting the available information on animal behavior in the camera trap data.
21 February 2020 in Remote Sensing in Ecology and Conservation
Camera traps have become an important tool in wildlife monitoring. However, an issue in interpreting their data in statistical analyses of population densities, demography or behaviour is that the probability of detecting the target animals and their behaviours may vary depending on environmental and methodological factors. A specific problem is the type of flash used in the camera trap, as animals may react differently to different flash types and change their avoidance or habituation behaviour accordingly over time. Here, we provide the first systematic test of the impact of flash type in studies of red deer (Cervus elaphus) and roe deer (Capreolus capreolus), based on an analysis of behavioural responses to white, standard infrared and black flashes during 900 camera trap deployments in the Bavarian Forest National Park and the Northern Black Forest. The results revealed that both deer species were more likely to react to standard infrared than to black flash, but trigger delays prevented comparisons to white flash. Red deer reacted more frequently to camera traps than did roe deer, and responses were more common in the Northern Black Forest than in the Bavarian Forest National Park, where hunting is severely restricted. Contrary to our expectations, camera trapping rates of free‐ranging deer did not significantly decline over time for any flash type or species. Despite the lack of evidence for avoidance behaviour, we recommend the use of black flash for behavioural studies of deer populations to minimize the risk of introducing a source of disturbance whereas infrared and white flash are equally suitable for determinations of demographic parameters.
18 June 2016 in Journal of Ornithology
13 October 2023 in Ecology and Evolution
Among other approaches, camera trap distance sampling (CTDS) is used to estimate animal abundance from unmarked populations. It was formulated for videos and observation distances are measured at predetermined ‘snapshot moments’. Surveys recording still images with passive infrared motion sensors suffer from frequent periods where animals are not photographed, either because of technical delays before the camera can be triggered again (i.e. ‘camera recovery time’) or because they remain stationary and do not immediately retrigger the camera following camera recovery time (i.e. ‘retrigger delays’). These effects need to be considered when calculating temporal survey effort to avoid downwardly biased abundance estimates. Here, we extend the CTDS model for passive infrared motion sensor recording of single images or short photo series. We propose estimating ‘mean time intervals between triggers’ as combined mean camera recovery time and mean retrigger delays from the time interval distribution of pairs of consecutive pictures, using a Gamma and Exponential function, respectively. We apply the approach to survey data on red deer, roe deer and wild boar. Mean time intervals between triggers were very similar when estimated empirically and when derived from the model‐based approach. Depending on truncation times (i.e. the time interval between consecutive pictures beyond which data are discarded) and species, we estimated mean time intervals between retriggers between 8.28 and 15.05 s. Using a predefined snapshot interval, not accounting for these intervals, would lead to underestimated density by up to 96% due to overestimated temporal survey effort. The proposed approach is applicable to any taxa surveyed with camera traps. As programming of cameras to record still images is often preferred over video recording due to reduced consumption of energy and memory, we expect this approach to find broad application, also for other camera trap methods than CTDS.
14 November 2023 in Methods in Ecology and Evolution
Density estimates guide wildlife management, and camera traps are commonly used to estimate sizes of unmarked populations. Unfortunately, animals often alter their natural behaviour in the presence of camera traps, which may bias subsequent density estimates. We simulated 100 populations of known density to test several new and existing methods that aimed to reduce bias in density estimates from camera trap distance sampling (CTDS) and the random encounter model (REM). Within our simulated populations, we introduced different behavioural reactions including attraction towards cameras, freezing when near cameras and fleeing from cameras. CTDS and REM provided density estimates with decent coverage of confidence intervals (CTDS = 94%, REM = 87%), mean coefficient of variation (CTDS = 0.121, REM = 0.071) and minimal bias (root‐mean squared error: CTDS = 1.336, REM = 0.913) for simulated populations with no reactive behaviour. However, failure to implement a method to account for reactive behaviour resulted in low coverage, large bias and potentially imprecise density estimates when 30% of the simulated population potentially reacted by attraction to or fleeing from camera traps. We identified a corrective strategy that enhanced confidence interval coverage, increased precision and reduced bias for every behavioural reaction except when individuals potentially fled from cameras. Synthesis and applications. We provide empirically tested methods for reducing bias of density estimates. Wildlife managers requiring population estimates of animals that exhibit reactive behaviour can use our methods to reduce inaccuracy. We encourage future studies to quantify behavioural responses to camera traps and to implement, test and possibly extend our methods to reduce bias through simulation.