Department of Chemistry, Catalysis, and Materials Chemistry Laboratory, National Institute of Technology Karnataka, Surathkal, D.K., Karnataka 575 025, India
Auto-generated profile, based on publicly available information
Badekai Ramachandra Bhat
Department of Chemistry, Catalysis, and Materials Chemistry Laboratory, National Institute of Technology Karnataka, Surathkal, D.K., Karnataka 575 025, India
Biomass waste-derived activated carbon has a wide range of applications, including air and water purification, gas separation, energy storage, and catalysis. This material has become increasingly popular in recent years as a result of the growing demand for sustainable and eco-friendly materials. In this study, Mangifera indica leaf waste-derived activated carbon has been investigated as an electrode material for high-performance supercapacitors. The dried Mangifera indica leaves were first carbonized using FeCl 3 and then activated using KOH to increase their surface area and pore structure at different temperatures. The activated carbon prepared at 725 °C has shown a high specific capacitance of 521.65 F g −1 at a current density of 0.5 A g −1 and also achieved an energy density of 17.04 W h kg −1 at a power density of 242.50 W kg −1 in the 6 M KOH electrolyte. Significantly, it has demonstrated remarkable electrochemical cycling stability, retaining 96.60% of its initial capacity even after undergoing 10 001 cycles at a scan rate of 500 mV s −1 . The superior electrochemical performance of the activated carbon can be attributed to its high surface area of 1232.63 m 2 g −1 , well-distributed pore size, and excellent degree of graphitization, which all facilitate the rapid diffusion of ions and enhance the accessibility of the electrolyte to the electrode surface. Hence, this study provides a promising route for utilizing waste biomass as a low-cost, sustainable electrode material for energy storage devices.
1 December 2015 in Sensors and Actuators B: Chemical
A nanorod shaped nickel hydroxide coated ferrite nanocatalyst was synthesized by a traditional co-precipitation method. The particle size of the nanoferrite was tuned using a variable surfactant ratio to achieve a high surface area. A very high BET surface area (334.55 m2 g−1) was achieved for particles with sizes of 40–130 nm. The superparamagnetic reusable catalyst was found to be active for the selective liquid phase oxidation of alcohols with hydrogen peroxide as a mild oxidant. Nickel hydroxide acted as a Bronsted base working in synergy with the nanoferrite catalyst for alcohol oxidation. The catalytic system was found to catalyse primary and secondary alcohols efficiently (86%) to their corresponding carbonyls in good yields.
Manganese oxide is a fascinating material for use as a thin-film electrode in supercapacitors. Herein, the consequences of copper incorporation on spray pyrolyzed manganese oxide thin films and their electrochemical performance were investigated. The Cu-incorporated manganese oxide thin films were deposited by spray pyrolysis, and their structural and electrochemical properties were thoroughly evaluated. The formation of the spinel Mn3O4 phase with effective Cu incorporation was confirmed by X-ray diffraction investigation. Through Raman studies, it was noticed that mixed phases of manganese oxide tend to form after Cu incorporation, and this result was also reflected in X-ray photoelectron spectroscopic studies. The surface morphology and roughness were also altered by the addition of copper. However, electrochemical measurements implied a reduction in the specific capacitance upon copper inclusion. The cyclic voltammetry test indicated a specific capacitance of 132 F/g for Mn3O4 electrodes, but a substantial drop for copper-incorporated samples due to the mixed manganese phase. The decremental tendency was further supported by galvanostatic charge-discharge studies and electrochemical impedance spectroscopic measurements. These results provide valuable insights into the effects of copper addition in manganese oxide thin-film-based electrodes for energy storage applications.