A novel application of an 8 × 8 Butler matrix in broadband multiport measuring systems has been presented. The proposed measuring system consists solely of a single broadband 8 × 8 Butler matrix and only one isolator allowing for measurements of all S-matrix coefficients of any two-port device. It has been shown that the properties of the applied 8 × 8 Butler matrix allow to obtain high measurement accuracy, which has been estimated with a numerical procedure for a different number of applied power detectors. The improved analytical procedure of calibration necessary for the transmission coefficient measurement has been presented. Performance of the proposed measuring system has been experimentally verified in a wide frequency range of 2-3.5 GHz, by measurements of S-parameters of seven exemplary attenuators and a narrowband bandpass filter. The measurement results are very close to the values obtained with the use of a commercial vector network analyzer.
In this paper the effect of curvature radius on radiation patterns in multibeam antennas fed by a Butler matrix has been shown. Calculation results taking into account the change of amplitude and phase of the signal received at each radiating element caused by the array curvature for different radii have been presented. A simple compensation technique is studied which allows us to achieve proper radiation patterns by adding phase shifters in outer channels. It is shown that by using this technique we can obtain radiation patterns of conformal antenna arrays which with respect to the side lobes are comparable with planar antenna arrays. Measurement results of a 4times1 conformal antenna array fed by a Butler matrix are presented and agree well with the calculated ones
4 August 2014 in IEEE Microwave and Wireless Components Letters
A novel method allowing for improvement of input match and output balance of Marchand balun with connecting line has been presented. The proposed compensation technique together with the ideal Marchand balun design formulas allow for achieving an arbitrary impedance transformation ratio even for the circuit having a long connecting line. The theoretical analysis has been verified by EM simulations and measurements of a Marchand balun composed of 3 dB coupled-line sections and 30° transmission line operating at the center frequency f 0 = 1.15 GHz and terminated at input and outputs with 50 Ω and 100 Ω, respectively.
The paper presents an antenna design for use in a nonlinear junction detection device. To achieve wide bandwidth a capacitive feed technique is used in which small probe feed elements are coupled to the radiating patch. In order to minimize the overall antenna size both receiving and transmitting antenna elements have been integrated into one dual-band structure having two separate excitation ports. High isolation between ports is achieved to avoid direct interferences between a transmitter and a receiver. Results of theoretical analysis are presented agree well with the experimental ones.
20 August 2014 in IEEE Transactions on Antennas and Propagation
A novel approach for realization of a feeding network allowing for achieving dual-circular polarization in the slot-coupled microstrip antenna lattice has been proposed. The presented feeding network is an eight-port composed of four 3\mathchar"702DdB/90 ° directional couplers, and when appropriately integrated with the four-port series-fed antenna lattice ensures a full symmetry of the antenna layout and produces simultaneously right-handed and left-handed circular polarization. The proposed low-profile, low-cost solution can be easily integrated with the antenna lattice, and it allows for reduction of the introduced dissipation losses comparing to the known solutions, i.e., external feeding networks such as Butler matrices or power combiner/divider networks connected via coaxial cables. The proposed concept has been examined by measurements of the manufactured feeding network integrated with the previously developed antenna lattice operating at 5.4 GHz.