1 October 2019 in Applied Computing and Geosciences
22 June 2020 in Applied Physics Letters
Resistance drift in amorphous Ge2Sb2Te5 is experimentally characterized in melt-quenched line cells in the range of 300 K to 125 K and is observed to follow the previously reported power-law behavior with drift coefficients in the range of 0.07 to 0.11 in the dark, linearly decreasing with 1/kT. While these drift coefficients measured in the dark are similar to commonly observed drift coefficients (∼0.1) at and above room temperature, measurements under light show a significantly lower drift coefficient (0.05 under illumination vs 0.09 in the dark at 150 K). Periodic on/off switching of light shows a sudden decrease/increase in resistance, attributed to photo-excited carriers, followed by a very slow response (∼30 min at 150 K) attributed to contribution of electron traps and slow trap-to-trap charge exchanges. A device-level electronic model is used to relate these experimental findings to gradual charging of electron traps in amorphous Ge2Sb2Te5, which gives rise to growth of a potential barrier for holes in time and, hence, resistance drift.
11 October 2022 in Cell Reports Physical Science
30 November 2020 in IEEE Transactions on Nanotechnology
The rapid quench from melt associated with the reset operation in phase change memory is a suitable physical process to leverage programming variability for hardware security. We have experimentally characterized cell-to-cell programming variability in Ge2Sb2Te5 (GST) line cells using a single reset voltage pulse with moderate amplitude. We have observed that the cell dimensions and programming pulse parameters play a critical role on the programming variability. Cells with larger length-to-width ratios (L/W 1.8) show greater programming variability when moderate reset voltage amplitudes (Vappl) are applied. This variability is further increased with shorter pulse edges (tedge) of the applied pulses. We have performed a study for a reset-variability-based physical unclonable function (PUF) with 85 cells (with L/W = 4) by applying identical single pulses with shorter tedge and a pre-calibrated Vappl. Cells are randomly programmed to the full reset (high-resistance-state or HRS), or the partial reset or set (low-resistance-state or LRS) states with an equal probability and the two states are separated by ~1.5 order of magnitude. No bit flipping is observed after 9 months of programming and instead, the separation increases to ~3 orders of magnitude because of the upward and downward resistance drift of the HRS and LRS states. The underlying physical mechanisms behind the enhanced variability are identified as thermal runaway at the onset of GST melting and the additional current overshoot due to the parasitic capacitances, based on the results obtained from COMSOL finite element simulations and SPICE circuit modeling of the experimental setup.
24 June 2024 in Applied Physics Letters
We electrically characterized melt-quenched amorphized Ge2Sb2Te5 (GST) phase-change memory cells of 20 nm thickness, ∼66–124 nm width, and ∼100–600 nm length with and without photoexcitation in the 80–275 K temperature range. The cells show distinctly different current–voltage characteristics in the low-field (≲19 MV/m), with a clear response to optical excitation by red light, and high-field (≳19 MV/m) regimes, with a very weak response to optical excitation. The reduction in carrier activation energy with photoexcitation in the low-field regime increases from ∼10 meV at 80 K to ∼50 meV at 150 K (highest sensitivity) and decreases again to 5 meV at 275 K. The heterojunctions at the amorphous–crystalline GST interfaces at the two sides of the amorphous region lead to formation of a potential well for holes and a potential barrier for electrons with activation energies in the order of 0.7 eV at room temperature. The alignment of the steady state energy bands suggests the formation of tunnel junctions at the interfaces for electrons and an overall electronic conduction by electrons. When photoexcited, the photo-generated holes are expected to be stored in the amorphous region, leading to positive charging of the amorphous region, reducing the barrier for electrons at the junctions and hence the device resistance in the low-field regime. Holes accumulated in the amorphous region are drained under a high electric field. Hence, the potential barrier cannot be modulated by photogenerated holes, and the photo-response is significantly reduced. These results support the electronic origin of resistance drift in amorphous GST.