Bastien Mamdy

Bastien Mamdy

Auto-generated profile, based on publicly available information

Bastien Mamdy

STMicroelectronics, Crolles, France

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 February 2023 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
AJAli Jouni
Ali Jouni
MSMathieu Sicre
Mathieu Sicre
VMVictor Malherbe
Victor Malherbe
BMBastien Mamdy
Bastien Mamdy
TTThomas Thery
Thomas Thery
VGVincent Goiffon
Vincent Goiffon
Dark count rate (DCR) degradation is measured on 40-nm 2D and stacked CMOS SPADs after proton irradiations. Mean DCR increase is plotted for different displacement damage doses (DDD) for two biasing conditions. Due to field enhancement effects such as Poole-Frenkel and phonon-assisted-tunneling, Non-Ionizing Energy Loss (NIEL) scaling is found to be dependent on the excess bias. Moreover, the associated damage factors are higher compared to pixels with unity gain photodiodes. A model predicting DCR increase with DDD based on field enhancement factor equations and damage energy deposited by the proton induced recoil spectrum is established and fits well with experimental data. Finally, activation energies are extracted: low values between 25 °C and 60 °C confirm the domination of field effects over thermal generation. Furthermore, large energy discrepancies seen at a fixed DCR increase are suggesting that defect structures could also have an impact on DCR distributions.

5 April 2021 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
VMVictor Malherbe
Victor Malherbe
SPSerge De Paoli
Serge De Paoli
BMBastien Mamdy
Bastien Mamdy
GGGilles Gasiot
Gilles Gasiot
PRPhilippe Roche
Philippe Roche
We report on alpha and neutron irradiation of 7.8 μm Single-Photon Avalanche Diodes (SPADs) manufactured in 40nm CMOS. Displacement damage leads to persistent dark count rate hot spots, due to carrier generation centers introduced by radiation. Defects are studied as a function of temperature and electrical stress, with live acquisitions evidencing large amounts of short-term annealing of the damage, and sometimes also random telegraph signal. Average damage factors and defect activation energies are consistent with a large field-enhancement of carrier generation. Since some radiation-induced defects lead to out-of-spec behavior, the implications for the reliability of SPAD-based systems are also discussed, by projecting the associated terrestrial failure rates.

19 April 2022 in IEEE Journal of the Electron Devices Society
Verified
Journal Article
Open access
RHRemi Helleboid
Remi Helleboid
DRDenis Rideau
Denis Rideau
JGJeremy Grebot
Jeremy Grebot
INIsobel Nicholson
Isobel Nicholson
NMNorbert Moussy
Norbert Moussy
PDPhilippe Dollfus
Philippe Dollfus
A new method to reliably simulate the PDE and jitter tail for realistic three-dimensional SPAD devices is presented. The simulation method is based on the use of electric field lines to mimic the carriers’ trajectories, and on one-dimensional models for avalanche breakdown probability and charges transport. This approach allows treating a three-dimensional problem as several one-dimensional problems along each field line. The original approach is applied to the McIntyre model for avalanche breakdown probability to calculate PDE, but also for jitter prediction using a dedicated advection-diffusion model. The results obtained numerically are compared with an extensive series of measurements and show a good agreement on a wide variety of device designs.

15 March 2023 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
AJAli Jouni
Ali Jouni
VMVictor Malherbe
Victor Malherbe
BMBastien Mamdy
Bastien Mamdy
TTThomas Thery
Thomas Thery
MSMathieu Sicre
Mathieu Sicre
VGVincent Goiffon
Vincent Goiffon
Defects induced by 62 MeV protons in SPADs are studied. A study of the Dark Count Rate (DCR) variation after irradiations for different biasing conditions underlines the predominance of field enhancement effects such as Poole-Frenkel effect and phonon-assisted-tunneling over band-to-band tunneling. Activation energy measurements below mid-gap value confirm the important contribution of these field effects. However, unexpected behaviors in these energies are seen: very low activation energies are extracted for SPADs with a DCR induced around 10 3 counts per second. We attribute them to the contribution of different groups of defects, with different energy level distribution. This analysis is completed with an annealing study between 100 °C and 300 °C. Results for high DCR SPADs correlate well with the presence of defect clusters. Moreover, histogram of the annealing temperature at which the DCR starts to drop displays two peaks at 170 °C and 250 °C. The first one is attributed to phosphorus vacancies and complex cluster of defects with an energy distribution inside the Si bandgap centered above mid-gap. The second one is attributed to clusters of divacancies that also anneal at temperatures around 250 °C.

4 June 2024 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
AJAli Jouni
Ali Jouni
BMBastien Mamdy
Bastien Mamdy
VMVictor Malherbe
Victor Malherbe
VLValérian Lalucaa
Valérian Lalucaa
CVCédric Virmontois
Cédric Virmontois
VGVincent Goiffon
Vincent Goiffon
X-ray and γ-ray irradiations are performed on Frontside Illuminated (FSI) 2D-planar and Backside Illuminated (BSI) 3D-stacked CMOS single photon avalanche diodes (SPADs). Different degradations are observed for nearly the same deposited Total Ionizing Dose (TID). 2D-SPADs are only slighty degraded, with a Dark Count Rate (DCR) which increases after 320 krad(SiO2) with X-rays, while the DCR spectrum after 300 krad(SiO 2 ) with γ-rays is spread towards high DCR (3 to 4 decade increase). As these SPADs are less sensitive to ionizing radiation effects, this suggests a strong domination of the displacement damage contribution of γ-rays due to secondary electrons induced by Compton scattering, leading to point defects inside the silicon bulk. A large DCR tail in the distribution is also observed with 3D-stacked SPAD pixels but the histogram peak is close to the one caused by X-rays. This suggests that 3D-stacked SPADs are more sensitive to ionizing radiation due to a larger Si/SiO 2 interface area that can be degraded and a designed electric field imposed by the BSI configuration that maximizes charge collections in the avalanche region. Activation energy measurements confirm this result, by comparing data with a 62-MeV proton irradiation. The DCR alteration dependence with the SPAD voltage during X-ray irradiations is also studied, with an increasing degradation with the SPAD bias. Then, the Random Telegraph Signal (RTS) behavior of the DCR is studied: while X-rays do not induced DCR fluctuations, different RTS characteristics are observed between the two technologies, suggesting a major role of point defects. Comparisons with proton irradiations and an annealing study strengthen this assumption.

28 November 2023 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
AJAli Jouni
Ali Jouni
VMVictor Malherbe
Victor Malherbe
BMBastien Mamdy
Bastien Mamdy
TTThomas Thery
Thomas Thery
VCVincent Correas
Vincent Correas
VGVincent Goiffon
Vincent Goiffon
Different proton energies were used to irradiate 2D- and 3D-CMOS Single-Photon Avalanche Diodes (SPAD) under different biasing conditions. Discrepancies are underlined between biased SPADs (active irradiation) and unbiased SPADs (passive irradiation) in terms of mean Dark Count Rate (DCR) degradations. Non-Ionizing Energy Loss (NIEL) scaling of the average DCR is then discussed for the two technologies studied, followed by a discussion on the median DCR increase. Coulomb scattering, nuclear elastic and inelastic interactions and their contributions to the total NIEL are used to explain similarities and differences observed for the mean and the median DCR increase, depending on the proton energy. Radiation tolerance comparison between 2D- and 3D-technology is also tackled. Finally, DCR increase distributions are investigated to understand and confirm the analysis on the mean and median DCR alteration.