Agnieszka Kłopotowska

Agnieszka Kłopotowska

Auto-generated profile, based on publicly available information

Agnieszka Kłopotowska

Faculty of Geology, Warsaw University, Warsaw, Poland

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2014 in Studia Geotechnica et Mechanica
Verified
Journal Article
Open access
PDF file
AKAgnieszka Katarzyna Klopotowska
Agnieszka Katarzyna Klopotowska
PŁPawel Łukaszewski
Pawel Łukaszewski
The paper is focused on changes of geomechanical properties with regard to loss of long-term resistance in studies on the influence of salt spray on the structure of selected rocks from Poland. The investigation has shown that the analyzed rock material shows variable susceptibility to this corrosive factor. The most susceptible to ageing by salt mist were Śmiłów sandstones, whose progressive deterioration was observed in subsequent cycles. Analysis of resistance parameters has shown decreased resistance to uniaxial compression exceeding 30% also in the case of the Józefów limestones. Limestones from Raciszyn have revealed high resistance to ageing by salt mist.

1 September 2016 in Acta Geologica Polonica
Verified
Journal Article
Open access
PDF file
AKAndrzej Konon
Andrzej Konon
SOSzymon Ostrowski
Szymon Ostrowski
BRBarbara Rybak-Ostrowska
Barbara Rybak-Ostrowska
MLMirosław Ludwiniak
Mirosław Ludwiniak
MŚMichał Śmigielski
Michał Śmigielski
AKAgnieszka Kłopotowska
Agnieszka Kłopotowska
A newly recognized Mnin restraining stepover is identified in the Permo-Mesozoic cover of the western part of the Late Palaeozoic Holy Cross Mountains Fold Belt (Poland), within a fault pattern consisting of dextral strike-slip faults. The formation of a large contractional structure at the Late Cretaceous – Cenozoic transition displays the significant role of strike-slip faulting along the western border of the Teisseyre-Tornquist Zone, in the foreland of the Polish part of the Carpathian Orogen. Theoretical relationships between the maximum fault offsets/ mean step length, as well as between the maximum fault offsets/mean step width allowed the estimation of the values of possible offsets along the Snochowice and Mieczyn faults forming the Mnin stepover. The estimated values suggest displacements of as much as several tens of kilometres. The observed offset along the Tokarnia Fault and theoretical calculations suggest that the strike-slip faults west of the Late Palaeozoic Holy Cross Mountains Fold Belt belong to a large strike-slip fault system. We postulate that the observed significant refraction of the faults forming the anastomosing fault pattern is related also to the interaction of the NW-SE-striking faults formed along the western border of the Teisseyre- Tornquist Zone and the reactivated WNW-ESE-striking faults belonging to the fault systems of the northern margin of the Tethys Ocean.

1 September 2013 in Studia Geotechnica et Mechanica
Verified
Journal Article
Closed access
PDF file
AKAgnieszka Katarzyna Kłopotowska
Agnieszka Katarzyna Kłopotowska
PŁPaweł Łukaszewski
Paweł Łukaszewski
The de-icing salt has been used for decades to increase safety on the roads and sidewalks. In Poland, mainly the sodium chloride is used in order to maintain the roads in good condition during winter. Like other salts used for surface de-icing, it depresses the freezing point to lower temperatures and has an additional thermal effect by an exothermic reaction. However, this salt causes the accumulation of chlorides in the walls and stone buildings contributing to the deterioration of these facilities. The paper addresses the issue of the influence of salt solutions on the structure and geomechanical properties of rocks at negative temperatures. The study was conducted on the basis of cyclic tests which simulate complex action of both the negative temperature and the salty environment. The conditions for the tests were chosen so as to reflect the actual conditions of the winter in Poland. During the tests, the longitudinal wave propagation velocity, changes in weights of the samples as well as visual changes were recorded which allowed continuous tracking of occurring changes. At the end of the tests, the rock samples were subjected to uniaxial compressive tests. For this purpose, four lithological types were chosen, representing the sedimentary rocks: clastic and carbonate, widely used in stone constructions.

5 January 2018 in International Journal of Earth Sciences
Verified
Journal Article
Open access
PDF file
AKAgnieszka Kłopotowska
Agnieszka Kłopotowska
This paper attempts to show the relationship between joints observed in flysch formations in the field and microfracture fabrics invisible to the naked eye in hand specimens. Ultrasonic measurements demonstrate that the intensity and orientations of domains “memorised” by rock specimens are associated with the historical stresses within the rock mass rather than the rock lamination. The spatial orientations of these microfractures have been measured, and their dynamic-elastic properties have been found to correlate with the orientation of macroscopic joint sets measured in the field. The elastic properties measured vary because of sedimentary diagenetic processes that occured during the tectonic deformations of these flysch rocks in the Podhale Synclinorium of Poland. The structural discontinuities detected by ultrasonic measurements can be perceived as an incipient phase of the macroscopic joints already visible in the field and are attributed to the in situ residual tectonic stresses. Such historical stresses impart a hidden mechanical anisotropy to the entire flysch sequence. The microfractures will develop into macroscopic joints during future relaxation of the exposed rock mass. Understanding the nature and orientation of the invisible microfracture anisotropy that will become macroscopic in the future is vital for the safe and efficient engineering of any rock mass.