1 December 2007 in Tectonophysics
1 December 2006 in Tectonophysics
1 May 2013 in Tectonophysics
10 July 2013 in Journal of Geophysical Research: Solid Earth
We investigated properties of frictional sliding of plagioclase, pyroxene, and their mixture gouges with a small amount of hornblende, biotite, and quartz as accessory minerals, under hydrothermal conditions with an effective normal stress of 200 MPa, pore pressure of 30 MPa, and temperatures from 100°C to 600°C. Axial loading rate was stepped between 0.001 and 0.0001 mm/s to acquire the rate dependence. Both plagioclase and pyroxene gouges showed velocity‐weakening behavior in the whole temperature range except the velocity‐strengthening behavior of pyroxene at 200°C. For temperatures above 400°C, both plagioclase and pyroxene gouges showed oscillatory slips, as a result of small dc values of 3–4 µm which make the critical stiffness rise remarkably and approach the system stiffness. Above 300°C, the direct effect of plagioclase shows an increasing trend with temperature, indicating control of the deformation process by thermally activated mechanisms. As the difference of a and b values here are only 20% at most, this trend also applies to the evolution effect. Our analytical derivation based on the theory of pressure solution shows a log‐linear contact area growth with time that corresponds to an evolution effect, and estimations based on this encompass the plagioclase data, though the identification of actual mechanisms is not easy. Finally, it is found that a little quartz (3–5%) added to the plagioclase (60–62%)‐pyroxene (35%) mixture has a strong stabilizing effect, leading to a transition from velocity weakening to velocity strengthening. These results may help constrain the depth range of seismic slips on deep faults in the lower crust of gabbroic composition.
1 May 2014 in Tectonophysics
8 June 2021 in Geophysical Research Letters
Native and fluid circulation‐induced metamorphic products may affect the stability of faults in geothermal reservoirs–particularly epidote (Ep) and chlorite (Cl). Our laboratory experiments conducted at hydrothermal conditions show that these two minerals, when precipitated on natural faults, may promote fault instability or failure under conditions typifying a geothermal reservoir. Shear experiments on Ep‐rich fault gouges indicate potentially unstable frictional behavior—more pronounced at elevated temperatures and pore fluid pressures—and indicate increased potential for the nucleation of slip instability relative to that of the host granodiorite gouge. Experimental results indicate in particular that Ep can increase the potential for induced seismicity on existing faults. Increased proportions of Cl in gouges stabilize the faults but apparently lower the frictional strength. Our results reveal that the metamorphic minerals exert a subtle but potentially significant control on fault strength and stability in geothermal reservoirs.