28 June 2024 in Optics Express
A passively mode-locked alexandrite laser was developed with a single-walled carbon nanotubes (SWCNTs) saturable absorber (SA), which was pumped by a 638 nm red laser. After using a pair of prisms for dispersion compensation, the narrowest pulse width of 70 fs was achieved at a repetition rate of 100 MHz. The mode-locked laser had a signal-to-noise ratio greater than 55 dB and a beam quality factor of less than 1.13. A high average output power of 386 mW was achieved with a slope efficiency of 12.4%. It is the first time a passively mode-locked alexandrite femtosecond laser pumped by a 638 nm red laser has been developed. Moreover, it is also the first time that SWCNTs are used as SAs to achieve a passively mode-locked laser in the visible light range.
23 February 2023 in Journal of Materials Chemistry C
A high-quality 2 μm ultrafast laser is successfully developed using a zirconium pentatelluride saturable absorber mirror (ZrTe5-SAM) composed of a layered structure of ZrTe5. Continuous wave mode-locked (CWML) operation has been demonstrated in the fabricated laser with Tm:YAG ceramic as the laser gain medium. Ultrafast pulses as short as 4.8 ps are obtained with a maximum average output power of 767 mW and a repetition frequency of 56 MHz, at a central wavelength of 2014 nm. To the best of our knowledge, this is the highest average output power achieved so far, for a passively mode-locked laser at 2 μm using a two-dimensional (2D) saturable absorber (SA). This study opens new doors for the development of high power 2 μm ultrafast lasers.
7 April 2025 in High Power Laser Science and Engineering
This paper presents an investigation of the secondary saturation characteristics of a HfTe2 saturable absorber. Pulse energies of 5.85 and 7.4 mJ were demonstrated with a high-order Hermite–Gaussian (HG) laser and a vortex laser, respectively, using alexandrite as the gain medium. To the best of our knowledge, these are the highest pulse energies directly generated with HG and vortex lasers. To broaden the applications of high-energy pulsed HG and vortex lasers, wavelength tuning in the region of 40 nm was achieved using an etalon.
6 August 2024 in Optics & Laser Technology
26 March 2025 in Optics Express
Zinc-sulfide (ZnS) polycrystalline co-doped with Cr2+ and Fe2+ ions, when used as a saturable absorber (SA), exhibits a longer recovery time and a larger excited state absorption cross-section compared to Fe:ZnS polycrystalline, due to the sensitizing effect of co-doping. The energy level structure and energy transfer process of Fe,Cr:ZnS polycrystalline were analyzed. A 2.7 µm wavelength passively Q-switched (PQS) pulsed laser was simulated and experimentally tested. The experiment achieved a narrower pulse width of 78 ns with a repetition rate of 44 kHz, compared to the Fe:ZnS SA Q-switched laser. The experimental results closely matched the simulation in terms of pulse profile, repetition rate, and pulse width. To the best of our knowledge, this is the first time that Fe,Cr:ZnS polycrystalline is used as a SA to realize PQS lasing. The superior characteristics of co-doped crystals as SAs have also been highlighted.
28 October 2025 in Laser & Photonics Reviews