In this work, quantitative assessment of surface damage in terms of parameters like surface crack density and recast layer thickness in wire electrical discharge machining (WEDM) process has been undertaken. The effect of processing conditions on crack formation is studied using scanning electron microscope. Surface crack density and recast layer thickness analysis in terms of machining parameters such as pulse on time, pulse off time, peak current, spark gap voltage significantly deteriorate the microstructure of machined samples, which produces the deeper, wider overlapping craters, pock marks, globules of debris and micro cracks. The microstructure analysis of WEDM surface was based upon the theory of electrical discharge phase and metallurgical physics. It is found that the pulse on time, pulse off time and peak current are the most dominating parameters for both surface crack density and recast layer thickness.
7 May 2015 in Journal of Industrial Engineering International
Electric discharge drill machine (EDDM) is a spark erosion process to produce micro-holes in conductive materials. This process is widely used in aerospace, medical, dental and automobile industries. As for the performance evaluation of the electric discharge drilling machine, it is very necessary to study the process parameters of machine tool. In this research paper, a brass rod 2 mm diameter was selected as a tool electrode. The experiments generate output responses such as tool wear rate (TWR). The best parameters such as pulse on-time, pulse off-time and water pressure were studied for best machining characteristics. This investigation presents the use of Taguchi approach for better TWR in drilling of Al-7075. A plan of experiments, based on L27 Taguchi design method, was selected for drilling of material. Analysis of variance (ANOVA) shows the percentage contribution of the control factor in the machining of Al-7075 in EDDM. The optimal combination levels and the significant drilling parameters on TWR were obtained. The optimization results showed that the combination of maximum pulse on-time and minimum pulse off-time gives maximum MRR.
16 April 2013 in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
This research work explores the relationship of machining parameters such as pulse on time (Ton), pulse off time (Toff), peak current (Ip), spark gap voltage, wire feed and wire tension on the material removal rate, wire wear ratio and surface roughness for pure titanium in wire electric discharge machining process. The Box–Behnken design had been utilized to plan the experiments, and response surface methodology was employed for developing the empirical models. The peak current, spark gap voltage, pulse on time, pulse off time and interaction between pulse on time and peak current affected the surface roughness significantly. Multi-response optimization of process parameters was obtained using desirability approach. Furthermore, the selected machined samples were analyzed using energy-dispersive X-ray analysis, scanning electron microscope and X-ray diffraction techniques. The predictions from this model were validated by conducting confirmatory experiments.
23 September 2014 in International Journal of Manufacturing Engineering
Electrical discharge machining is one of the earliest nontraditional machining, extensively used in industry for processing of parts having unusual profiles with reasonable precision. In the present work, an attempt has been made to model material removal rate, electrode wear rate, and surface roughness through response surface methodology in a die sinking EDM process. The optimization was performed in two steps using one factor at a time for preliminary evaluation and a Box-Behnken design involving three variables with three levels for determination of the critical experimental conditions. Pulse on time, pulse off time, and peak current were changed during the tests, while a copper electrode having tubular cross section was employed to machine through holes on EN 353 steel alloy workpiece. The results of analysis of variance indicated that the proposed mathematical models obtained can adequately describe the performances within the limits of factors being studied. The experimental and predicted values were in a good agreement. Surface topography is revealed with the help of scanning electron microscope micrographs.