15 October 2023 in Structures
5 December 2024 in Progress in Additive Manufacturing
This study aims to investigate the fatigue resistance of additively manufactured steel plates with galvanized surfaces using a Zn–5Al alloy. In addition to fatigue tests, this study examined the effect of hot-dip galvanization (HDG) on fatigue resistance by investigating the surface roughness, zinc layer condition, and quasi-static tension on both galvanized and ungalvanized specimens. The filling effect of the zinc coating using a Zn–5Al alloy on the surface was also examined, as it influences the surface shape and smooths local areas, leading to an improvement in fatigue resistance compared with conventional galvanized surfaces. Overall, this study provides insight into the effects of HDG on the fatigue resistance of additively manufactured steel plates with galvanized surfaces.
20 June 2026 in Welding in the World
The structural integrity of welded steel components depends on the quality of the welding process. Internal imperfections such as porosity and lack of penetration are unavoidable in practical fabrication. Although design standards assume defect-free connections, such imperfections may reduce load-bearing capacity and affect structural safety. This study investigates the influence of internal weld defects on the static performance of butt-welded steel connections. A comprehensive experimental program was conducted on large-scale tensile specimens with intentionally introduced internal imperfections. Lack of penetration and porosity. Material properties were characterized by tensile, Charpy impact, and hardness tests. Non-destructive testing using ultrasonic testing with the total focusing method (TFM) was performed to quantify defect size and distribution. Quasi-static tensile tests were subsequently carried out at room temperature and − 30 °C to evaluate the influence of defect characteristics on load-bearing and deformation behavior. The results show that lack of penetration reduces the ultimate load-bearing capacity, particularly for one-sided root gaps due to eccentric stress states, although the reduction is smaller than predicted by cross-sectional area loss alone. Porosity exhibited a differentiated effect: isolated pores had little influence, whereas clustered porosity altered failure modes and reduced ductility, especially at low temperatures. For both defect types, elastic stiffness and the onset of strain hardening were largely unaffected. Overall, internal weld imperfections affect static resistance less severely than EN ISO 5817 suggests, implying conservative acceptance criteria. These conclusions are limited to quasi-static tensile loading and do not extend to fatigue, fracture mechanics, or multiaxial conditions.