1 January 2023 in Građevinski materijali i konstrukcije
Risk is involved in the whole lifecycle of a structure: design, construction, utilization, and demolition. There is a close connection between reliability and risk. Contemporary building codes introduce consideration of reliability in structural design. Here, the concept of risk takes into account the level of consequences of a failure. Structural engineers, who are used to deterministic calculation procedures, are often unfamiliar with the uncertainties associated with risk analysis. An overview of the basic principles of risk management in civil engineering is presented in this paper.
1 January 2023 in Građevinski materijali i konstrukcije
The paper presents three-dimensional numerical models of short concrete-filled steel tubular circular columns that can successfully describe the column behaviour under axial compression. Several of the most commonly used material models for the steel part and a concrete portion of the column are evaluated in the models. In addition, the paper presents a new proposal for the extension of the Eurocode 2 stress-strain relation to make it suitable for describing the complex behaviour of concrete inside the steel tube. This model overcomes the current limitations of the Eurocode 2 design guide, referring to the limitation for the concrete curve in compression to 3.5%o strain. The ultimate axial column strength obtained by the proposed model is compared to the ultimate column capacity calculated by a simplified method provided in Eurocode 4. All presented numerical models are validated on a set of experiments from the literature and demonstrate good agreement. The comments about the accuracy of each model are provided, along with the identified limitations.
1 January 2023 in Gradjevinski kalendar
Eurocode 2 does not provide explicit guidance for the shear design of elements with circular cross-section - the terms in the provisions are intended for elements with concentrated tensile reinforcement, such as beams subjected to bending. The most common elements with circular cross-section are columns and piles, which typically have uniformly distributed reinforcement around the circumference and significant axial force. It is necessary to adjust the relevant inputs in order to formulate procedures of reasonable complexity, which are suitable for practical application. The paper presents the application of the Eurocode's 2 model for shear design on circular cross-section elements. Simple instructions are given for practical calculations that are on the safe side, covering all aspects of shear design: shear resistance of concrete, shear resistance of reinforcement, maximum shear resistance and calculation of additional tensile reinforcement. The procedures are illustrated with a numerical example in accordance with the national document SRPS EN 1992-1-1/NA.