A high-power quantum-dot superluminescent diode is demonstrated under continuous-wave operation, with an output power of 137.5 mW and a corresponding spectral bandwidth of 21 nm. This represents not only the highest output power, but also a record-high power spectral density of 6.5 mW/nm for a CW-operated superluminescent diode in the 1.1 - 1.3 μm spectral region, marking more than a 6-fold increase with respect to the state of the art. The two-section contact layout of the reported device introduces additional degrees of freedom, which enable a wide tunability of the bandwidth and power depending on the desired application. A maximum bandwidth of 79 nm was recorded, with an output power of 1.4 mW. The high-power continuous-wave operation of this device would be particularly relevant for continuous, high-speed, high-sensitivity spectroscopy, imaging and sensing applications, as well as in optical communications.
This letter reports on InP/GaInP quantum dot mode-locked lasers emitting in the 730 nm wavelength region, extending the spectral range of previously reported monolithic mode-locked edge-emitting lasers. Modal gain and absorption measurements were used to identify a relatively broad spectrum which is utilised to support passive mode-locking in a monolithically integrated two-section ridge laser. The conditions for mode-locking were explored by varying the current to the gain section and reverse bias to the absorber section. For a total cavity length of 3 mm, the shortest pulse train observed was 6 ps in duration with a repetition rate of 12.55 GHz.
A wide spectral asymmetry between the front and rear facets of a tapered chirped quantum dot multi-section superluminescent diode is reported. The spectral asymmetry between the two facet outputs was found to be tunable and highly dependent on the bias asymmetry between the two contact sections, with a spectral mismatch of up to 14 nm. Numerical simulations confirmed a relationship between this spectral asymmetry and the non-uniform filling of the quantum dots’ confined states when different current densities are applied to the device electrodes. The results from this investigation open up an additional degree of freedom for multi-section superluminescent diodes, which could pave the way for optical bandwidth engineering via multiplexing the spectral output from both facets, using only a single device.
Pure Q-switching (self-pulsating) behaviour is shown for the first time in an optically injected two-section quantum-dot laser. Upon CW optical injection, it was possible to switch the operation regime from free-running mode-locking to locked Q-switching. Under this regime, the pulse repetition rate of around 1 GHz was tunable with injection power (by more than 100 MHz) and absorber reverse bias. Moreover, through injection-locking, the Q-switched output was spectrally tunable by around 7 nm, by tuning the master laser. The seamless switch between mode-locking and Q-switching with optical injection as well as the tunability and control afforded by injection-locking could open up a range of applications, such as in multi-modal imaging. On a more fundamental level, this investigation has also generated new insights into the dynamics of quantum-dot lasers and the optical injection process.