29 September 2023 in Soils and Rocks
Phenomena that do not obey Terzaghi’s principle of effective stress (PES) are related to strain rate and time effects. This issue led the author to refer to early articles in soil mechanics, which used to consider the shear resistance of clays as a combination of two components: a frictional and a viscous one. In these articles the viscous component was assigned to the distortion of highly viscous adsorbed water layer in the contact points between grains along the plane where shearing takes place. Assuming the shear resistance of plastic soils comprises frictional and viscous resistance components, a shear stress equation can be added to the PES. It is shown that Mohr’s circle of effective stress is the sum of two ellipses: the viscosity and the friction ellipses. The ordinates of the viscosity and the friction ellipses represent the viscous and the frictional components of shear resistance in different planes, respectively. This approach leads to a failure criterion considering strain rate, according to which failure takes place whenever the friction ellipse touches the strength envelope, which is the 'e φ sloped straight line passing through the origin, 'e φ being the Hvorslev’s true angle of friction. By adding such shear stress equation to the PES, a model that explains strain rate and time effects is developed. Predictions of the proposed model are compared to results from tests carried out on San Francisco Bay Mud specimens.
30 July 2021 in Geotecnia
A influência da velocidade de carregamento no comportamento de geo-materiais e, por decorrência, na estimativa de seus parâmetros constitutivos se constitui em um dos desafios da engenharia geotécnica. Durante eventos dinâmicos ou carregamentos rápidos, como terremotos, o solo exibe comportamento distinto daquele observado ao longo da vida útil da estrutura, gerando poro pressões elevadas e tensões cisalhantes mobilizadas pela parcela de escoamento viscoso. No outro lado do espectro, baixas taxas de deformações produzem drenagem parcial durante o cisalhamento e, nestes casos, a resistência mobilizada não corresponde a comportamento não-drenado. Este artigo discute o comportamento de solos quando submetidos a uma ampla gama de taxas de deformação, discutindo efeito das condições de drenagem necessárias para a transição entre uma resposta drenada a velocidades de deformação baixas, para uma resposta não-drenada ou viscosa especialmente em ensaios realizados a altas taxas de deformação. O artigo reúne pesquisas desenvolvidas no Brasil e em Portugal, enfatizando suas contribuições à prática de projetos geotécnicos.
1 September 2012 in Soils and Rocks
The undrained remoulded shear strength of a clay, sur, is an important parameter in the design of a number of geotechnical applications. In the case of onshore tests the value ofsur is generally obtained from vane tests. Recently, cyclic T-bar tests have been used to obtain the sur value, especially for offshore applications. Seventeen T-bar cyclic tests in two deployments have been performed at Sarapuí II soft clay test site. In a third deployment only penetration was recorded. The presence of roots has influenced the values of the initial penetration in one of the deployments, as observed in another test site, which is a consequence of the shape of the penetrometer and may be considered a shortcoming of the test. Therefore, to know whether roots have influenced the test results in a site at least two repeatable tests must be performed. If cyclic tests are performed, their results can provide a good indication of the influence of the roots. Considering the vane shear test as reference for obtaining su and sur, NT-bar obtained from tests not affected by the roots ranged from 8.8 to 10.9, with an average of 9.8, while Nrem, T-bar ranged from 14.1 to 19.5, with an average of 16.3. Therefore NT-bar values (related to the natural condition) were smaller than Nrem, T-bar (related to the remoulded condition). The equations suggested by Yafrate et al. (2009) to evaluate the remoulded penetration resistance, the whole degradation curve and the sensitivity, based only on the initial penetration and extraction resistances have provided good results for the Sarapuí II soft clay, except in the case of very shallow depths.
1 September 2013 in Soils and Rocks
Thick wall (6.6 mm wall thickness) plastic samplers, 97.2 mm in internal diameter (area ratio of 29%), 700 mm in length (length of soil sample 640 mm), with a cutting edge angle of 23°, without clearance and with a sampler head have been used to collect very soft clay samples at Sarapuí II test site. Very good to excellent and good to fair quality samples have been surprisingly obtained in most cases, which were attributed to a combination of five factors: the absence of an inside clearance, the low friction of the plastic sampler, the small “trick” to close the top of the sampling rods assuring that suction would be imposed on the top of the sample, the very careful handling and trimming process, combined with no extrusion of the sample, and the small ratio between specimen diameter and sample diameter. It is still too early to propose the use of thick wall plastic samplers - in combination with the procedures outlined above - to be used in regular undisturbed soft clay sampling, and more research is needed to identify the role of each procedure in the final result. However, if confirmed, the procedures adopted will allow significant cost saving with respect to the use of thin wall brass (or stainless steel) samplers.
30 June 2026 in Proceedings of the Institution of Civil Engineers - Geotechnical Engineering
A methodology is presented for evaluating past and future settlements of an area where fill was placed over soft clay some time before the site development – a situation frequently encountered in engineering practice. The proposed approach integrates field and laboratory tests to assess the consolidation stage and estimate settlement development over time. The case study addresses a fill constructed to raise the grade of an area of the campus of the Federal University of Rio de Janeiro, Brazil, which was subsequently developed as a Technological Park. The company leasing the land for a 50-year period required an assessment of the magnitude and rate of settlements expected during the lease term. The testing programme was designed to be cost- and time-effective while still providing results with reasonable accuracy. The consolidation stage was evaluated using in situ pore-pressure measurements obtained with a small-diameter piezometric probe, while the clay consolidation properties were determined from laboratory tests. Established consolidation theories were used to estimate settlement development over time, considering both primary and secondary consolidation.
2 July 2026 in Soils and Rocks
Cohesion was defined by Coulomb in the eighteenth century as the strength of a prismatic solid body subjected to a direct tensile test. However, in geotechnics, different meanings have been ascribed to the term cohesion causing conceptual confusion. To distinguish the several meanings assigned to the term cohesion, it is common to find it followed by a complementary term to indicate its meaning. Examples include true cohesion, apparent cohesion, cohesion intercept and Hvorslev’s true cohesion. Each of these terms is defined, distinguishing them by their physical interpretation. For this, it was necessary to visit some historical articles from the eighteenth and nineteenth centuries, as well as some articles from the 1930s and 1940s. In addition to the historical aspects presented, the interpretation of rock weathering as a loss of Coulomb’s cohesion and the interpretation of “Hvorslev’s true cohesion” as being of a viscous nature are discussed.