18 April 2017 in Energy & Environmental Science
Asymmetric Faradaic system based on organometallic electrodes shows suppression of parasitic water reactions and remarkable selectivity in redox-mediated electrosorption of micropollutants.
21 March 2023 in Journal of the American Chemical Society
23 August 2021 in Journal of Materials Chemistry A
Rare earth elements (REEs) play an essential role in our modern society, being critical resources for electronic devices and renewable energy technologies. Efficient platforms for REE recovery and purification are essential to resource security and environmental management. Imparting electrochemical control over an adsorbent system can lead to higher modularity and sustainability, by enabling adsorbent regeneration without the use of additional chemicals. For the reversible capture and release of REEs, we design and synthesize a redox-copolymer, poly(ferrocenylpropyl methacrylamide-co-methacrylic acid) (P(FPMAm-co-MAA)), that combines an ion-exchange carboxyl group for REE adsorption, and a redox-active ferrocene moiety for regeneration based on electrochemical control. By molecularly tuning the copolymer composition, efficient adsorption uptake could be achieved alongside electrochemically regenerated adsorbent reuse. The copolymer electrodes exhibited an Y(III) adsorption capacity of 69.4 mg Y per g polymer, and electrochemically mediated regeneration efficiency close to 100% through oxidation of the ferrocenium units. The copolymer sorbent showed stoichiometric binding for cerium (Ce), neodymium (Nd), europium (Eu), gadolinium (Gd), and dysprosium (Dy) based on carboxyl active sites. Our work provides a proof of concept for electrochemically regenerable ion-exchange copolymers for REE recovery, and we envision generalized applications of this concept in electrifying ion-exchange systems and cation-selective separations.
27 September 2024 in Nature Communications
A major challenge in per- and polyfluoroalkyl substances (PFAS) remediation has been their structural and chemical diversity, ranging from ultra-short to long-chain compounds, which amplifies the operational complexity of water treatment and purification. Here, we present an electrochemical strategy to remove PFAS from ultra-short to long-chain PFAS within a single process. A redox-polymer electrodialysis (redox-polymer ED) system leverages a water-soluble redox polymer with inexpensive nanofiltration membranes, facilitating the treatment of varied chain lengths of PFAS without membrane fouling. Our approach combines both ion migration by electrodialysis (for PFAS with chain lengths ≤C4) and electrosorption strategies (for PFAS with chain lengths ≥C6) to eliminate approximately 90% of ultra-short-, short-chain, and long-chain PFAS. At the same time, we achieve continuous desalination of the source water down to potable water level. The redox-polymer ED exhibits remarkable PFAS removal in real source water scenarios, including from matrices with 10,000 times higher salt concentrations, as well as secondary effluents from wastewaters. Additionally, the removed PFAS is mineralized with a defluorination performance between 76-100% by electrochemical oxidation, highlighting the viability of integrating the separation step with a reactive degradation process.
25 September 2020 in Advanced Energy Materials
Water‐soluble, and ferrocene‐containing methacrylamide copolymers with different comonomer ratios of the solubility‐promoting comonomer [2‐(methacryloyloxy)‐ethyl]‐trimethylammonium chloride (METAC) are synthesized in order to obtain a novel, temperature‐stable electrolyte for aqueous redox flow batteries. The electrochemical properties of one chosen polymer are studied in detail by cyclic voltammetry and rotating disc electrode (RDE) investigations. Additionally, the diffusion coefficient and the charge transfer rate are obtained from these measurements. The diffusion coefficient from RDE is compared to the value from synthetic boundary experiments at battery concentrations, using an analytical ultracentrifuge, yielding diffusion coefficients of a similar order of magnitude. The polymer is further tested in a redox flow battery setup. While performing charge and discharge experiments against the well‐established bis‐(trimethylammoniumpropyl)‐viologen, the polymer reveals high columbic efficiencies of >99.8% and desirable apparent capacity retention, both at room temperature as well as at 60 °C. Further experiments are conducted to verify the stability of the active compounds under these conditions in both charge states. Lastly, the electrochemical behavior is linked to the characteristics of the polymers concerning absolute values of the molar mass and diffusion coefficients.
7 April 2023 in ACS Energy Letters