Pyrolysis–gas chromatography (Py-GC) using a vertical microfurnace pyrolyzer was applied to the precise determination of the ‘within-tree variation’ of the ratio of syringyl and guaiacyl units (S/G ratio) for lignin in Eucalyptus camaldulensis. On the pyrogram of the Eucalyptus obtained at 450 °C, many characteristic peaks derived from syringyl and guaiacyl units of lignin were reproducibly observed, together with those from cellulose and hemicellulose. On the basis of the relative intensities of those characteristic peaks relating to the syringyl and guaiacyl units, the ‘within-tree variation’ of the S/G ratio was determined precisely in about 1 h using only about 0.1 mg of the powdered wood sample with a 2% relative standard deviation. The results obtained were also compared with those obtained by the thioacidolysis method.
Biodegradability of poly(butylene succinate-co-butylene adipate) (PBSA) was studied based on its copolymer composition determined by thermally assisted hydrolysis and methylation-gas chromatography (THM-GC) using trace amounts (20 µg) of the film samples. The copolymer compositions of butylene adipate (BA) units gradually decreased with soil burial degradation time, reflecting preferential biodegradation of BA moieties during soil burial due to their lower crystallinity. Furthermore, local differences in biodegradability of a given PBSA film after soil burial were also successfully evaluated.
Thermally assisted hydrolysis and methylation-gas chromatography (THM-GC) in the presence of an organic alkali was applied to the direct analysis of copolymer composition for poly(3-hydroxybutyrate-co-3-hydroxyvalerate) [P(3HB-co-3HV)] accumulated in whole bacterial cells. Cupriavidus necator was grown on a liquid medium with different molar ratios of valeric acid (V) to glucose (G) in order to control the compositions of P(3HB-co-3HV) produced in the cells. Trace amounts (0.03 mg) of dried Cupriavidus necator cells were directly subjected to THM-GC in the presence of tetramethylammonium hydroxide (TMAH) at 400 degrees C. The obtained chromatograms clearly showed nine characteristic peaks, attributed to the THM products from 3HB and 3HV units in the polymer chains, without any appreciable interference by the bacterial matrix components. Based on these peak intensities, the copolymer compositions were determined rapidly without using any cumbersome sample pretreatment. Moreover, the compositions thus obtained were in good agreement with those obtained by the conventional technique.