This study focused on the production of angiotensin‐converting enzyme inhibitory peptides (ACEIPs) from peanut meal (Arachis hypogaea Linn) fermented by Lactobacillus pentosus. The fermentation process was optimized using the response surface methodology with ACE inhibitory activity as the experimental indicator. ACEIPs were further purified after fermentation using ultrafiltration and Sephadex G‐25 gel chromatography. The effect of different molecular weights (ranging from 0.5 to 1.5 kDa) of ACEIP on ACE inhibitory activity was investigated, and a maximum inhibitory rate of 48.83% was achieved. The content of ACEIP was 78.95%. Amino acid analysis revealed that the hydrophobic amino acids accounted for 43.09% of the total content. Among the identified amino acids, glutamic acid had the highest content of 14.94%, followed by leucine and aspartic acid. Matrix‐assisted laser desorption/ionization time‐of‐flight–mass spectrometry (MS) and liquid chromatography–tandem MS were used to identify the molecular weights of the selected ACEIPs, yielding six ACEIPs with good stability and high hydrophilicity. Flexible docking of the six ACEIPs with ACE was simulated using AutoDock Vina (v1.5.7). The result showed that the ACEIPs formed 11, 8, 7, 9, 7, and 6 hydrogen bonds with ACE residues, and the lowest binding energies between them were −9.8, −8.1, −9.0, −9.3, −8.2, and−9.1 kcal/mol, respectively. Among them, GFGINAENNHRIF exhibited superior ACE inhibitory activity and binding stability.
Objective. To evaluate the stress status of fracture site caused by femoral neck shortening and to analyze the stress of fracture site and the implants from the finite element point of view. Methods. CT scan data of hip of a normal adult female were collected. Three‐dimensional reconstruction MICs and related module function simulation was used to establish the postoperative shortening model of femoral neck fracture with Pauwels angle > 50°, which was treated with cannulated screws. The models were divided into four groups: normal femoral neck, shortening in 2.5 mm, shortening in 7.5 mm, and shortening in 12.5 mm. The finite element analysis software msc.nastran2012 was used, and the data of maximum stress and stress nephogram of fracture site and implants were carried out. Results. From normal femoral neck to shortening in 12.5 mm of the femoral neck, the maximum tensile stress increased gradually in the fracture site above the cannulated screws while compressive stress decreased gradually in the fracture site below the cannulated screws, and the maximum stress of the cannulated screws increased gradually with obvious stress concentration at the screw holes in the fracture site, and the peak value of stress concentration was about 179 MPa. Conclusion. The biomechanical environment of the fracture site changed by femoral neck shortening. With the increasing of femoral neck shortening, the stress of the fracture site and implants would be uneven; then, the stability of fracture site would become worse, and the possibility of implant sliding or even breakage would be increased.