The 2016 Kumamoto earthquake sequence started with a M J (Japan Meteorological Agency magnitude) 6.5 event on April 14, and culminated in a M J 7.3 event on April 16. Associated with the sequence, approximately 34-km-long surface ruptures appeared along the eastern part of the Futagawa fault zone and the northernmost part of the Hinagu fault zone. We carried out an urgent field investigation soon after the earthquake to map the extent and displacement of surface ruptures with the following results. (1) The rupture zone generally consisted of a series of left-stepping en echelon arrays of discontinuous fault traces of various lengths. (2) Slip exceeding 100 cm occurred on previously unrecognized fault traces in the alluvial lowland of the Kiyama plain and on the western rim of the Aso volcano caldera. (3) Large slip with maximum dextral slip of 220 cm was measured throughout the central section of the rupture zone along the Futagawa segment, and the slip gradually decreased bilaterally on the adjoining northeastern and southwestern sections. (4) The surface rupture mostly occurred along fault traces mapped in previous active fault investigations. (5) Most of the surface ruptures were produced by the mainshock, and significant postseismic slip occurred after the mainshock. Graphical Abstract .
Southwest Japan is located in the subduction margin between the continental Amurian and oceanic Philippine Sea plates. Recent land GNSS (Global Navigation Satellite System) and offshore Global Positioning System-Acoustic geodetic measurements were used to clarify the deformation in and around these plate margins. We examined strain partitioning and interplate coupling using a block modeling approach on the observed velocities. Although the main plate boundaries are the Nankai Trough and Sagami trough, our results suggest that one-third of the relative plate motion between the two plates is accommodated by several block boundaries in the southeastern margin of the Amurian plate. The most active boundaries, with a slip rate of ≥8 mm/yr, cross southwest Japan from the Okinawa Trough through the Median Tectonic Line and Niigata Kobe tectonic zone, to the eastern margin of the Japan Sea. A subparallel boundary with a slip rate of 4–5 mm/yr is along the coastline of Japan. These two boundaries have a right-lateral shear motion that accommodates part of the interplate motion, with a boundary across the Korean Peninsula and Japan Sea. The slip partitioning results in an eastward decrease of relative block motion from 78 to 4 mm/yr along the Nankai Trough and Suruga trough. Interplate coupling is moderate to strong at 10–25 km depth along the Nankai Trough, but it is lower at ∼132°E, ∼136°E, and ∼137°E than in the surrounding regions, corresponding to the segment boundaries of past megathrust earthquakes, suggesting that regions of insufficient strain accumulation act as a barrier for earthquake rupture.
28 August 2013 in Journal of Geophysical Research: Solid Earth
Temporal changes to interplate coupling and long‐term aseismic slip in the Tokai Region of central Japan from July 1996 to June 2009 are statically inverted using continuous Global Positioning System (GPS) data and leveling observations, and examined using a new interpretation of aseismic slip. In this interpretation, the interplate coupling and the aseismic slip should be inferred and compared with reference to a state of no coupling on the plate interface rather than assuming steady state interplate coupling before the occurrence of the aseismic event as previous works have done. For this purpose, we used original time series data without subtracting any linear trends. The inferred distribution shows that the entire period can be divided into three subperiods based on the existence of the aseismic slip area from 2000 to 2005. The strength of the interplate coupling does not change throughout the observed period even though the distribution narrows along the dip direction after the aseismic slip terminates. The aseismic slip area inferred in this study, based on the no‐coupling reference, was determined to be deeper than the area where the long‐term slow slip event (SSE), defined as the slip corresponding to the residual displacement from the steady state, was hypothesized to have occurred in numerous previous studies. The total seismic moment released by the aseismic slip is equivalent to a Mw∼6.6 earthquake while the SSE in previous works was considered to be equivalent to a Mw∼7.0 to 7.1 earthquake. This difference can be attributed primarily to the effects on the interplate coupling, which previous studies did not take into account when defining the SSE. The aseismic slip area coincides well with the distribution of other types of plate interactions, such as short‐term slow slip events and low‐frequency earthquakes.
An intermediate-strength earthquake of magnitudeMj6.8 occurred on July 16, 2007, centered beneath the Japan Sea a few kilometers offshore of Niigata Prefecture in central Japan. We constructed a dense GPS network to investigate postseismic deformation after this event, choosing our GPS sites carefully so as to complement the nationwide GPS GEONET array. Coseismic displacements caused by the mainshock detected at some GEONET sites were used to estimate coseismic fault parameters. The results indicate that the geodetic data can be explained by a combination of two rectangular faults dipping northwest and southeast. Minor but definite postseismic deformation was detected largely in the southern part of the dense network. The time series of site coordinates can be characterized by a logarithmic decay function, and the estimated time constant seems to be almost similar in range to that of the 2004 Mid-Niigata Prefecture Earthquake. We also found a possible site instability at 960566 (Izumo-zaki, GEONET) caused by a small, local landslide associated with the mainshock and therefore concluded that the data obtained at this site should not be used for coseismic or postseismic analysis.
1 December 2015 in Earth and Planetary Science Letters