Juan Vicente Durá-Gil

Juan Vicente Durá-Gil

Auto-generated profile, based on publicly available information

Juan Vicente Durá-Gil

Universitat Politècnica de València

Research Focus & Metrics

Academic Career Length

33Years (1994-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 March 2018 in PeerJ
Verified
Journal Article
Open access
PDF file
BBBruno Bazuelo-Ruiz
Bruno Bazuelo-Ruiz
JDJuan V. Durá-Gil
Juan V. Durá-Gil
NPNicolás Palomares
Nicolás Palomares
EMEnrique Medina
Enrique Medina
SLSalvador Llana-Belloch
Salvador Llana-Belloch
The presence of fatigue has been shown to modify running biomechanics. Overall in terms of gender, women are at lower risk than men for sustaining running-related injuries, although it depends on the factors taken into account. One possible reason for these differences in the injury rate and location might be the dissimilar running patterns between men and women. The purpose of this study was to determine the effect of fatigue and gender on the kinematic and ground reaction forces (GRF) parameters in recreational runners. Fifty-seven participants (28 males and 29 females) had kinematic and GRF variables measured while running at speed of 3.3 m s−1 before and after a fatigue test protocol. The fatigue protocol included (1) a running Course-Navette test, (2) running up and down a flight of stairs for 5 min, and (3) performance of alternating jumps on a step (five sets of 1 minute each with 30 resting seconds between the sets). Fatigue decreased dorsiflexion (14.24 ± 4.98° in pre-fatigue and 12.65 ± 6.21° in fatigue condition, p < 0.05) at foot strike phase in females, and plantar flexion (−19.23 ± 4.12° in pre-fatigue and −18.26 ± 5.31° in fatigue condition, p < 0.05) at toe-off phase in males. These changes led to a decreased loading rate (88.14 ± 25.82 BW/s in pre-fatigue and 83.97 ± 18.83 BW/s in fatigue condition, p < 0.05) and the impact peak in females (1.95 ± 0.31 BW in pre-fatigue and 1.90 ± 0.31 BW in fatigue condition, p < 0.05), and higher peak propulsive forces in males (−0.26 ± 0.04 BW in pre-fatigue and −0.27 ± 0.05 BW in fatigue condition, p < 0.05) in the fatigue condition. It seems that better responses to impact under a fatigue condition are observed among women. Further studies should confirm whether these changes represent a strategy to optimize shock attenuation, prevent running injuries and improve running economy.

1 September 2001 in Journal of Sports Sciences
Verified
Journal Article
Closed access
Salvador Llana-BellochSalvador Llana-Belloch
Salvador Llana-Belloch
GBG. Brizuela
G. Brizuela
JDJ. V. Dura
J. V. Dura
AGA. C. Garcia
A. C. Garcia
Subjective tests based on information gathered using 'discomfort questionnaires' have been used widely in ergonomics. In this study, we used a similar method to examine the discomfort associated with the footwear worn in tennis matches. A sample of 146 tennis players from a population of approximately 4000 completed the questionnaire. We performed a descriptive analysis of the study variables. The associations between discomfort and pain and between discomfort and design errors were evaluated using cross-tabulation and chi-squared tests. We found that 9% of players considered their footwear to be uncomfortable, 23% considered it to be acceptable and 68% regarded it as comfortable. Six design errors were identified and five body areas were reported as experiencing discomfort due to the footwear. Factor analysis identified four factors related to discomfort and six design errors. Subsequent correlation analysis identified several relationships among these factors. There was a strong correlation (r = 0.187, P = 0.022) between plantar discomfort and incorrect arch support.

1 June 1994 in Foot & Ankle International
Verified
Journal Article
Closed access
PDF file
AGAna-Cruz Garcia
Ana-Cruz Garcia
JDJuan-Vicente Durá
Juan-Vicente Durá
JRJosé Ramiro
José Ramiro
JHJuan-Victor Hoyos
Juan-Victor Hoyos
PVPedro Vera
Pedro Vera
A new methodology of biomechanical analysis of materials for shoe inserts is presented. This methodology is based on the determination of the loads applied to the materials in real situations and its simulation by means of a dynamic testing machine. Both the rigidity and the energy-absorbing characteristics of the materials are investigated as a function of frequency. This methodology is applied to the study of several commercially available viscoelastic materials intended for shoe inserts in the treatment and prevention of degenerative joint diseases. The influence of thickness is investigated as well as the frequency-dependent behavior of the materials studied. Significant differences between materials and different behavior as a function of thickness and frequency were found. Poron materials were found to have the lowest rigidity, good for adequate pressure distribution, while Noene showed the highest energy absorption. A careful selection of the thickness of Sorbothane was found to be necessary for avoiding flattening of the material.

3 December 2014 in Journal of Sensors and Sensor Systems
Verified
Journal Article
Open access
Robert SchmittRobert Schmitt
Robert Schmitt
MKM. Köhler
M. Köhler
JDJ. V. Durá
J. V. Durá
JDJ. Diaz-Pineda
J. Diaz-Pineda
A company's aim is to develop products that engage user attention and evoke positive emotions. Customers base their emotional evaluation on product components that are relevant for their perception. This paper presents findings of both identifying relevant product components and measuring emotions evoked by relevant perceived product components. To validate results, the comparison with self-reporting methods identifies similarities and differences between explicit expressed and implicit recorded customer requirements. On the one hand, eye tracking is applied to deduce the attention provoked by perceived product components. In order to link the product strategy with product components, the paper presents results considering the fact that the gaze track is affected by current thoughts. (Köhler et al., 2013, 2014a, b; Köhler and Schmitt, 2012) On the other hand, since self-reporting tools are only useful for obtaining information about the conscious part of customers' emotions, there is a need for measurement methods that measure the changes in physiological signals (bio-signals). Arousal is similar to emotional intensity and is related to the galvanic skin response. Positive or negative emotions are defined by the valence that is measured by facial electromyography. Findings are presented that relate changes in bio-signals on the aesthetical design to the global product impression as well as to emotions and, subsequently, linking changes in physiological signals to the evaluation of semantic concepts and design parameters. The presented approach provides conclusions and valid information about products as well as product components that provoke certain emotions and about product components linked to a certain product concept, which could be part of a product strategy. Consequently, hard facts and special design rules for emotional product design can be deduced.

16 October 2018
Verified
Conference Paper
Open access
ABAlfredo Ballester
Alfredo Ballester
APAna Pierola
Ana Pierola
EPEduardo Parrilla
Eduardo Parrilla
JUJordi Uriel
Jordi Uriel
ARAna V. Ruescas
Ana V. Ruescas
SASandra Alemany
Sandra Alemany

1 August 2005 in Safety Science
Verified
Journal Article
Closed access
JDJuan V. Durá
Juan V. Durá
EAEnrique Alcántara
Enrique Alcántara
TZTomás Zamora
Tomás Zamora
EBEsther Balaguer
Esther Balaguer
DRDavid Rosa
David Rosa