5 October 2025 in Volgograd Journal of Medical Research
МДМихальченко Алексей Дмитриевич
Михальченко Алексей Дмитриевич
Determining the features of the Spee occlusal curve is an urgent task in prosthetic dentistry and orthodontics. In most cases, the curvature of the occlusal plane is determined on plaster models of the jaws. At the same time, there is very little information about the methods of constructing the Spee occlusal curve on the TRG in the lateral projection. Purpose. To develop a method for constructing the Spee curve on a lateral telerentgenogram and to analyze it in people with physiological and pathological occlusion, as well as to evaluate the change in the occlusal curve in the treatment of patients with the "straight" arc technique. Materials and methods. The study was multifaceted and included the analysis of telerentgenograms and orthopantomograms of young people with physiological variants of the occlusal relationship of antagonists. This study was a retrospective cohort study. The distance between the anterior and posterior occlusal points through which the occlusal line passed was measured. Using PowerPoint programs, it was possible to draw a circle along the line of closure of the teeth through the occlusal points. The radius of the circle was measured. The ratio of the radius of the circle to the length of the sagittal size of the occlusal line was evaluated. The depth of the occlusal curve was measured from the point of the largest bulge to the occlusal line. The statistical analysis included the calculation of averages (M) and the error of representativeness (±m). Results and discussion. In the course of the analysis, a method was developed for constructing the Spee curve on the TRG in a lateral projection based on the proportionality of the sagittal size of the occlusal line, measured between the anterior and posterior occlusal points of the inferior dental arch and the radius of the occlusal circle. The radius exceeded the sagittal distance of the occlusal line by an amount corresponding to the Fibonacci number (1.618) and the golden ratio principle. The performed treatment with the "straight" arc technique contributed to the normalization of occlusal balance and the anterior teeth edge, however, it did not correspond to the optimal occlusal status characterizing physiological occlusion. Conclusion. The data obtained formed the basis for the differential diagnosis of physiological and pathological variants of the Spee curve. It should be noted that the treatment of patients with the "straight" (flat) arc technique, regardless of the severity of the Spee curve before treatment, does not correspond to achieving the optimal occlusal status characterizing physiological occlusion.
31 July 2025 in Acta Universitatis Dentistriae et Chirurgiae Maxillofacialis
BACKGROUND: Advances in radiographic techniques continue to improve diagnostic capabilities, underscoring the relevance of this study. AIM: This work aimed to determine the diagnostic value of the occlusal–condylar circle on lateral cephalometric radiographs in patients with different types of occlusal relationships. METHODS: The study included two groups: group 1 comprised radiographs of patients with normal occlusion; group 2 included radiographs of patients with malocclusion and distal-extension edentulous defects. Geometric constructions were created on lateral cephalometric images using the PowerPoint software and established anatomical landmarks. The radius of the occlusal–condylar circle was defined as the distance from the superior point of the condylar head (Cond) to the distal occlusal point of the dental arch. RESULTS: In group 1, the line of the occlusal–condylar circle passed through the distal occlusal point of the second molar and a point corresponding to two-thirds of the Cond–A line. In group 2, cephalometric analysis focused on occlusal point positions in cases of malocclusion and dental-arch defects due to missing molars with vertical dentoalveolar overeruption of antagonists. CONCLUSION: The occlusal–condylar circle on lateral cephalometric radiographs can serve as a key reference for establishing the occlusal line in patients with malocclusion and in those who have molar-segment dental-arch defects. The findings may be applicable in clinical settings for diagnosing vertical occlusal anomalies and assessing the outcomes of prosthodontic treatment.
15 November 2025 in Acta Universitatis Dentistriae et Chirurgiae Maxillofacialis
BACKGROUND: Dental arch deformities associated with distal extension edentulous defects exhibit a wide range of clinical patterns, varying by location and severity, which underscores the clinical relevance of this study. AIM: This study aimed to assess the prevalence of variants of distal extension dental arch defects according to their location and the severity of vertical deformation, as evaluated using panoramic radiography. METHODS: This retrospective study included 102 panoramic radiographs from patients with distal extension dental arch defects and 54 panoramic radiographs obtained from patients after prosthodontic treatment. To assess defect location, each panoramic radiograph was divided into 4 quadrants (2 maxillary and 2 mandibular, right and left). Reference points and lines were applied to evaluate tooth position relative to these references and assess the severity of vertical dental arch deformation. RESULTS: In prosthodontic practice, nine principal forms of distal extension dental arch defects were identified, with varying prevalence. The most common variant consisted of defects confined to a single mandibular quadrant: it was observed in 27 patients (26.47% ± 4.37%). Rare variants included defects involving 2 quadrants across both arches, either unilaterally or bilaterally. Signs of vertical dental arch deformation were identified in panoramic radiographs of 39 of 54 patients after prosthodontic treatment (72.22% ± 8.29%). CONCLUSION: In most cases, prosthodontic treatment is performed without adequate consideration of the severity of occlusal pathology, which adversely affects the functional status of the maxillofacial system.
18 March 2025 in Yakut Medical Journal
A comparative analysis of the location of occlusal landmarks on orthopantomograms and teleroentgenograms in normal and abnormal occlusion was performed, which has a high level of information content when planning orthopedic treatment in patients with defects of the dental arches and dental-alveolar occlusion anomalies. During the comparative analysis of orthopantomograms and teleroentgenograms, it was determined that the infradental-occlusal horizontal, as a rule, was parallel to the gnathic horizontal. The ratio of the alveolar-articular line (Cond-A) to the length of the segment intersected by the articular circle line on the teleroentgenogram was 1.50±0.09. On the OPG, when analyzing the linear parameters, it was noted that the ratio of the distance from the point "Cond" to the intersection with the aesthetic median vertical to the segment of the articular circle intersected by the line was 1.61 ± 0.1, which was close in value to the Fibonacci number. This circumstance allowed the use of the "golden section" principle when determining the radius of the circle in case of anomalies in the position of molars in the vertical direction. Comparative analysis of the location of occlusal landmarks on the orthopantomogram and teleroentgenogram in the norm and in case of bite pathology showed that both methods of X-ray examination can be used in the clinic of orthopedic dentistry in the diagnosis of dentoalveolar forms of occlusion anomalies and for choosing treatment methods for patients with defects of the dental arches that are not limited from the distal side of the arch. In addition, the intersection point of the occlusal lines and infradental-occlusal horizontals, which are located in the same way on both types of radiographs, attracts attention, which makes both methods of radiographic examination acceptable in the clinical practice of dental prosthetics.
30 September 2023 in "Medical & Pharmaceutical Journal "Pulse"
15 October 2026 in Journal of Volgograd State Medical University
ШВШкарин Владимир Вячеславович
Шкарин Владимир Вячеславович
ДВДмитриенко Сергей Владимирович
Дмитриенко Сергей Владимирович
ДДДмитриенко Александр Дмитриевич
Дмитриенко Александр Дмитриевич
+6
Most methods of orthodontic treatment are aimed at correcting the position of the front teeth, among which there are pathological and physiological variants of protrusion and retraction. However, the differentiation of norm and pathology requires clarification and addition, which determines the relevance of the research. The aim of the study: To determine the criteria for determining the variants of the physiological and pathological position of the incisors. Research methodology: The study was multidimensional, retrospective, and included the analysis of telerentgenograms and cone-beam tomograms of 57 patients with physiological occlusion, 17 radiographs of patients with incisor position anomalies, and tomograms of 6 patients undergoing orthodontic treatment. The angles of inclination of the upper and lower incisors to the occlusal line were measured. Statistically, in the Microsoft Excel program, the average values of the indicators and the error of representativeness (M ± m) were estimated. The results of the research: The results of the study determined the optimal parameters of the position of the incisor segments in the jaw structure in various variants of the intrusive types of dental arches of physiological occlusion. The mesotrusic type is characterized by the angle of inclination of the upper incisor to the occlusal line from 53 to 58 degrees, while the antagonist's index ranged from 66 to 72 degrees. With physiological protrusion of the incisors, the upper incisor occlusal angle varied from 49 to 53 degrees, and the lower incisor angle from 60 to 65 degrees. For physiological incisor retrosion, the angle of inclination of the upper incisor to the occlusal line ranged from 58 to 64 degrees, and for the antagonist, the indicator ranged from 72 to 82 degrees. With an abnormal position of the incisor-jaw segments in the jaws, the position of the vertical axis of the incisors deviates from the optimal values corresponding to the typological type of the dental arch while maintaining compact bone tissue along the vestibular and lingual contours of the segment. Conclusion: The physiological protrusive position of the incisors is characterized by optimal angular parameters of the tooth inclination to the occlusal line, corresponding to the protrusive type of dental arches, and the presence of compact and spongy bone tissue along the vestibular and lingual contours of the segment. Pathological protrusion/retraction of the incisors is characterized by a deviation of the incisor slope from the optimal value with a violation of the integrity of the compact bone plate along the perimeter of the dental segment.