1 May 2017 in Coastal Engineering
Environmental contours are an established method in probabilistic engineering design, especially in ocean engineering. The contours help engineers to select the environmental states which are appropriate for structural design calculations. Defining an environmental contour means enclosing a region in the variable space which corresponds to a certain return period. However, there are multiple definitions and methods to calculate an environmental contour for a given return period. Here, we analyze the established approaches and present a new concept which we call highest density contour (HDC). We define this environmental contour to enclose the highest density region (HDR) of a given probability density. This region occupies the smallest possible volume in the variable space among all regions with the same included probability, which is advantageous for engineering design. We perform the calculations using a numerical grid to discretize the original variable space into a finite number of grid cells. Each cell's probability is estimated and used for numerical integration. The proposed method can be applied to any number of dimensions, i.e. number of different variables in the joint probability model. To put the highest density contour method in context, we compare it to the established inverse first-order reliability method (IFORM) and show that for common probability distributions the two methods yield similarly shaped contours. In multimodal probability distributions, however, where IFORM leads to contours which are dificult to interpret, the presented method still generates clearly defined contours.Comment: preprint of the accepted version, 14 pages, 10 figure
1 September 2021 in Ocean Engineering
1 October 2020 in Advanced Manufacturing: Polymer & Composites Science
21 February 2019 in Journal of Offshore Mechanics and Arctic Engineering
Offshore wind energy is experiencing rapid development and is expected to make up an even bigger part of the world's future energy mix. New installation concepts for offshore wind farms involve lifting operations of wind turbine components from floating vessels. These installation concepts will only be economic if the lifting operations are performed safely at sea states with high significant wave heights. In this paper, we give an overview of current technical solutions, which could be used to lift the components tower, nacelle, hub, and rotor blade from a floating vessel. We classify and analyze solutions found in patents and the academic literature and point out open problems, which need to be addressed to enable lifting operations at higher sea states than what is currently feasible. However, we restrict the paper to technical solutions concerning the interface between the vessel and the component as well as the interface between the component and the crane. Consequently, we analyze, classify, and discuss solutions for the seafastening, the lifting gear as well as motion compensation systems. We find that there exists a large number of solutions, which are specific for a single component, but few solutions, which are applicable to all components without major adaptations. Additionally, we miss hydraulic seafastening mechanisms, which are remotely controlled and synchronized with the lifting operation. Consequently, we argue that versatile interfaces between the component and the crane as well as remotely controlled and synchronized seafastening mechanisms are best suited to enhance the lifting process.
2 October 2017 in Lightweight Design worldwide