28 November 2024 in Advances in Mechanical Engineering
As an important load-bearing part of the automobile chassis, the subframe is connected to the body and suspension system, and it is of great significance to perform the research on subframe lightweighting to improve the ride comfort and handling stability of the automobile. In order to comprehensively reflect the influence of operating conditions on the subframe, and at the same time consider the performance requirements such as strength and modal, the lightweight design of the subframe was performed with the combination of multi-condition topology optimization and multi-objective optimization methods. A rigid-flexible coupled multibody dynamic model of the front suspension was constructed to extract the loads at each articulation point of the subframe under multiple working conditions. Furthermore, the subframe was optimized for multi-condition topology in combination with the compromise programing method. Subsequently, the subframe was reconstructed based on the topology optimization results and a radial basis function (RBF) neural network approximation model was constructed using the optimal Latin hypercube tests. Then, the NSGA-II algorithm was adopted for multi-objective optimization of the reconstructed subframe. The optimized front subframe satisfies the performance requirements with the first-order frequency increased by 4 Hz, a weight reduction of 2.5 kg, the lightweight rate reaches 9.1%.
23 November 2024 in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
The lightweight design of the automotive front subframe was performed by combining multi-condition topology optimization and multi-objective optimization approaches. Firstly, to avoid the singularity of the research condition, a rigid-flexible coupled multibody dynamic model of the front suspension was established to extract the loads at articulation points of the subframe under typical working conditions. Then, a finite element model of the front subframe was constructed for strength and modal analysis. Multi-condition topology optimization of the front subframe envelope was performed utilizing the compromise programming approach. The subframe was redesigned according to the optimization results to establish an explicit parametric model, which avoided the blindness of optimization. Three approximate models were established through the optimal Latin hypercube test method to improve the efficiency of subsequent optimization. Furthermore, three algorithms were employed for multi-objective optimization based on the approximate model with the highest accuracy. To enhance the reliability of the optimization results, a comparison of the lightweighting effect of the three algorithms was performed, and the NSGA-II algorithm was determined as the final algorithm due to its greater effectiveness in lightweighting. The optimized front subframe has met various performance specifications while increasing the first-order frequency by 10 Hz and reducing weight by 3.27 kg.
12 March 2025 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
The Solid Isotropic Microstructure with Penalization (SIMP) model, a material interpolation model in the variable density method, has been widely applied in structural topology optimization. When combining the Sigmund sensitivity filtering method with the Optimality Criterion (OC) method for solving the SIMP model, numerical instabilities and relatively low optimization performance are often observed. To address these challenges, an improved scheme based on the variable density method is proposed. Firstly, an improved material interpolation model is proposed to overcome the deficiencies of the SIMP model in terms of penalty efficiency and convergence speed. Secondly, an improved sensitivity filtering method based on the Gaussian weight function is proposed, which not only successfully suppresses checkerboards and mesh-dependence but also contributes to a superior filtering effect. Furthermore, a new gray-scale suppression operator is designed to develop a function that suppresses gray-scale elements. This function is subsequently integrated into the iterative formula of the OC method, forming the improved OC method, which is capable of completely eliminating gray-scale elements. Finally, the feasibility and effectiveness of the improved scheme are verified through several typical numerical examples.