Fahad Usman Khan

Fahad Usman Khan

Auto-generated profile, based on publicly available information

Fahad Usman Khan

Faculty of Engineering, University of Central Punjab (UCP), Lahore, Pakistan

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 May 2022 in IEEE Transactions on Sustainable Energy
Verified
Journal Article
Closed access
AMAli Faisal Murtaza
Ali Faisal Murtaza
HSHadeed Sher
Hadeed Sher
FKFahad Usman Khan
Fahad Usman Khan
ANAli Nasir
Ali Nasir
Filippo SpertinoFilippo Spertino
Filippo Spertino
Sliding mode controller (SMC) based MPPT systems are less effective due to input LCin tank of boost converter. The LCin tank at PV node creates the sinusoidal waves of Vpv/Ipv, due to which phase angle (φ) occurs between triangular wave of inductor current (IL) and sinusoidal Vpv. This creates the adverse effects on SMC operation. In this research work, a series capacitor based boost converter is developed without using the parallel LCin circuit. Consequently, Vpv/Ipv becomes triangular (pure/semi) and φ factor between Vpv and triangular IL is minimized. The proposed setup ensures a high frequency operation and better voltage regulation of SMC. Through theoretical, mathematical and experimental studies, the response of PV source with conventional converter and proposed converter have been analyzed. Finally, extensive simulation studies and experimental evidences are presented, which highlights the superior dynamic and steady efficiencies of PV system with proposed topology as opposed to conventional converter and other recently developed MPPT systems.

6 October 2020 in IEEE Access
Verified
Journal Article
Closed access
FKFahad Usman Khan
Fahad Usman Khan
AMAli Faisal Murtaza
Ali Faisal Murtaza
HSHadeed Ahmed Sher
Hadeed Ahmed Sher
Kamal Al-HaddadKamal Al-Haddad
Kamal Al-Haddad
FMFaisal Mustafa
Faisal Mustafa
In this article, cabling constraints of different photovoltaic (PV) configurations is addressed in three steps: 1) a cable selection criterion is developed in accordance with metric system defined by American Wire Gauge (AWG); 2) a mathematical model is designed, which estimates the cable length for any array size; and 3) cost functions are devised owing to estimate the cables capital expenditure. The aforementioned steps are developed for Series (S), Parallel (P), Series-Parallel (SP), Total-cross-tied (TCT), Bridge-Link (BL) and Honey-Comb (HC). A comprehensive mathematical model is developed for each of the above mentioned architectures in the context of cabling cost versus energy payback time. This cost analysis provides a clear snapshot to the designers of PV plant about the capital investments of cabling system of specific architecture and its potential energy payback time. At the end, a design example for each configuration is presented against an array size of 10 × 2 PV panels.