4 April 2023 in ACS Applied Materials & Interfaces
26 March 2025 in Nature Communications
Decoupling charge and heat transport is essential for optimizing thermoelectric materials. Strategies to inhibit lattice-driven heat transport, however, also compromise carrier mobility, limiting the performance of most thermoelectrics, including Fe2VAl Heusler compounds. Here, we demonstrate an innovative approach, which bypasses this tradeoff: via liquid-phase sintering, we incorporate the archetypal topological insulator Bi1−x
Sb
x
between Fe2V0.95Ta0.1Al0.95 grains. Structural investigations alongside extensive thermoelectric and magneto-transport measurements reveal distinct modifications in the microstructure, a reduced lattice thermal conductivity and a simultaneously enhanced carrier mobility arising from topologically protected charge transport along the grain boundaries. This yields a huge performance boost, resulting in one of the highest figure of merits among both half- and full-Heusler compounds, z ≈ 1.6 × 10−3 K−1 (z T ≈ 0.5) at 295 K. Our findings highlight the potential of topological-insulating secondary phases to decouple charge and heat transport and call for more advanced theoretical studies of multiphase composites.
14 May 2025 in Physical Review X
Materials where flattened electronic dispersions arise from destructive phase interference, rather than localized orbitals, have emerged as promising platforms for studying emergent quantum phenomena. Crucial next steps involve tuning such flat bands to the Fermi level, where they can be studied at low energy scales, and assessing their potential for practical applications. Here, we show that the interplay of highly dispersive and ultraflat bands inherent to these systems can lead to extreme interband scattering-induced electron-hole asymmetry, which can be harnessed in thermoelectrics. Our comprehensive theoretical and experimental investigation of Ni 3 In 1 − x Sn x kagome metals supports this concept, showing that it could lead to thermoelectric performance on par with state-of-the-art semiconductors such as Bi 2 Te 3 . In Ni 3 In , scattering-induced electron-hole asymmetry is, however, subdued by an exotic conduction mechanism arising from quantum tunneling of charge carriers between Dirac bands, unrelated to the flat band itself. We outline strategies to selectively switch off this tunneling transport through negative chemical pressure or strain. Our study proposes a new direction to explore in topological flat-band systems and vice versa introduces a novel tuning knob for thermoelectric materials. Published by the American Physical Society 2025
14 April 2025 in Journal of Materials Chemistry A
The pivotal role of intrinsic defects in nominally stoichiometric X(Fe0.5Ni0.5)Sb quaternary half-Heuslers (X = Ti, Zr, or Hf) is revealed. The Sb vacancies naturally occur during synthesis and can alter the conduction behavior from n-to p-type.
1 March 2020 in Materials Letters
11 November 2024 in Applied Physics Letters
SYSima Aminorroaya Yamini
There is evidence that magnetism can potentially increase the thermopower of materials, most likely due to magnon scattering, suggesting the incorporation of intrinsic magnetic semiconductors in non-magnetic thermoelectric materials. Here, samples of p-type Bi0.5Sb1.5Te3 with 10 at. % excess Te are ball-milled with varying ratios of the antiferromagnetic semiconductor CrSb (0, 0.125, 0.5, and 1 wt. %) to prepare bulk samples by spark plasma sintering technique. The thermopower of samples containing CrSb is increased due to an increase in the effective mass of the charge carriers, indicating that there is a drag effect originating from the magnetic particles. However, this was at the expense of reduced electrical conductivity caused by reduced charge carrier mobility. While overall only marginal improvements in power factors were observed, these samples exhibited significantly lower thermal conductivity compared to the single-phase material. As a result, a peak zT value of ∼1.4 was achieved at 325 K for the sample with 0.125 wt. % CrSb. These results highlight the potential of incorporating magnetic secondary phases to enhance the thermoelectric performance of materials.