Turbulence in the atmospheric surface layer, especially in deserts and semi-arid regions, significantly affects sand movement. In unstable stratification, turbulence exhibits complex intermittency, complicating its impact on saltation. This study uses wavelet transform analysis to examine the effects of turbulence intermittency in unstable stratification on saltation. Our analysis reveals that in unstable stratification, the energy distribution of turbulence is more dispersed, the intermittent characteristics are more significant, and the intermittent burst duration of streamwise turbulence is longer, while the vertical intermittent burst duration is shorter. The fitting formulas of the energy ratio and stratification stability of the streamwise wind speed, vertical wind speed, and temperature at different frequencies are given. In addition, there is a complex nonlinear relationship between stratification stability and friction velocity on saltation. In unstable stratification, the critical wind speed required for saltation is higher than that of near-neutral, and the jumping speed and horizontal transport are weakened. Moreover, the coherence between wind speed and saltation flux increases significantly at low frequency with the increase in instability, indicating that large-scale motion plays a key role in saltation under these conditions. The more unstable the stratification is, the more obvious the phase difference fluctuation of the low frequency part is, and the more unfavorable the formation of stable saltation sand conditions. This study reveals the turbulence intermittently and its complex effects on sand particle movement in unstable stratification, which is of great significance for predicting and controlling dust storms, land desertification, and soil erosion.
In the atmospheric surface layer (ASL), the anisotropic characteristics of turbulence become more complex due to the strong influence of heat flux and particle motion. In this paper, the effects of stratification stability and total saltation sand flux on turbulent anisotropy of ASL wall turbulence are systematically analyzed by using high-frequency 3D velocity, temperature, and saltation sand flux measured in the field. Our results show that the temperature gradient intensifies the spanwise turbulent motion and enhances the vertical motion asymmetry. Although the buoyancy-driven turbulence enhances the spanwise variation, the momentum transfer mode between the streamwise–vertical and spanwise–vertical does not change. With the increase in instability, the large-scale motions (LSM) of the spanwise velocity may be destroyed and more spanwise small-scale motions (SSM) formed. In addition, saltation increases the sharpness, randomness, and extreme frequency of spanwise velocity distribution, but does not change the momentum transfer mode. Saltation may enlarge the fluctuation range and scale of the spanwise velocity, but may not be the main factor affecting the anisotropy of SSM. These results can deepen people's understanding of wind-blown sand movement and turbulence properties in ASL, and provides empirical data and insights that can significantly contribute to the development and refinement of turbulence models, particularly those that need to account for the complex interplay between stratification stability, saltation sand flux, and turbulence anisotropy.
The essence of wind-blown sand movement is a particle movement system driven by high Reynolds number wall turbulence in the atmospheric surface layer (ASL). Understanding this phenomenon is crucial as the law and mechanism of sand movement have not been effectively revealed at present. In this study, we utilize the high-frequency time series data from the Oceano site, a renowned location for such studies, which includes streamwise wind velocity (u), wall-normal wind velocity (w), temperature (T), and total saltation mass flux (q) to delve deeper into wind-blown sand movement. The results indicate a positive correlation between T and w. Interestingly, this correlation not only escalates with height but also intensifies with the increase of the stratification stability parameters (z/L). Sand influences the intensity ratio of each quadrant to Reynolds stress without altering the time ratio. Both the ejection and sweep processes correlate well with z/L. Similarly, q also exhibits a good correlation with z/L. The buoyancy's impact on the low-frequency fluctuations of q might be through its effect on the low-frequency fluctuations of w, enhancing the sand transport capacity of w. This discovery holds profound implications for the study of two-phase flow in ASL and the precise prediction of surface sediment transport.
Based on the field observation data in the near-neutral atmospheric surface layer (ASL) at the Qingtu Lake Observation Array, a new experimental data processing of the second-order statistic distribution of the high Reynolds number wall turbulence was presented which considered the influence of the intense thermal convection events (ITCEs). Following the conventional data selection in the literature, i.e., |z/L|, it is known that the variation of the large- and/or the very-large-scale motions (LSMs and VLSMs) cannot be effectively performed only by this method, which motivates us to find other factors influencing these turbulent motions, e.g., the ITCEs. From the data analysis of the probability density distribution of vertical heat flux, it is found that although its mean value tends to zero, its variance is large rather than zero, which suggests to us some ITCEs exist in the natural motions, although it has less frequent occurrences. In order to characterize the effect of such ITCEs, an additional parameter ψ for scaling the ratio of the buoyancy force to the viscous force is proposed in the data selection progress. The results show that the greater the |ψ|, the greater the impact of the ITCEs on ASL wall turbulence. Furthermore, our investigation reveals that the ITCEs may be one of the reasons why the VLSMs exhibit the Top-Down mechanism.
1 March 2025 in International Journal of Geomechanics
The vortex-induced vibration characteristics of transmission conductors under wind fields constitute a critical factor influencing structural safety. This study establishes a three-dimensional fluid–structure interaction numerical model based on the large eddy simulation method, systematically investigating the two-degree-of-freedom vibration characteristics of transmission conductors in pulsating wind fields. The vibration process evolves through four distinct stages: initial small-amplitude steady state, frequency-locked large-amplitude state, transitional modulation phase, and ultimately nonlinear chaotic stage under high wind speeds. The research reveals that within specific parameter ranges of reduced wind speed (4 < Ur< 5) and transverse displacement amplitude ratio (0.7 <Ay< 1) identified as the transition zone of vortex wake modes, the wake flow exhibits unique unsteady characteristics. This transition in vortex shedding patterns triggers significant fluid–structure interaction effects, resulting in substantial enhancement of alongwind displacement. Analysis of aerodynamic work shows that drag force performs predominantly positive work during lock-in and nonlinear stages, sustaining streamwise motion, while lift force does negative work at crosswind peaks, limiting lateral excursions. These findings clarify the multi-stage evolution of vortex-induced vibration, elucidate the wake-driven mechanism of high-amplitude vibration, and quantify the complementary roles of shear-layer instability and phase-dependent lift/drag work in governing conductor dynamics.