In a dc microgrid, a bidirectional dc–dc converter is an essential link between voltage bus and energy storage system (ESS). When galvanic isolation and high efficiency are required, dual active bridge (DAB) converter is preferred. Due to the instability of renewable energy sources, the DAB converter may transmit high or low power to ESS. To improve the efficiency across wide power range, this article proposes a reactive power minimization and soft switching optimization algorithm that combines the augmented Lagrangian method and triple-phase-shift (TPS) modulation. Unlike an offline algorithm with look-up table, the proposed algorithm can compute phase-shift-angle online, avoiding a large database for various working conditions. A prototype with an 800 W rated power is built, and the efficiency test results validate the efficiency improvement over other TPS-based algorithms. Furthermore, a current regulation experiment demonstrates that the proposed algorithm is suitable for ESS charging, which must deal with varying output voltage and power demand.
25 August 2021 in IEEE Transactions on Industrial Electronics
A multiport converter with bipolar outputs to integrate renewable energy and energy storage into the bipolar dc bus is the desirable solution due to its high reliability and efficiency. A novel symmetric bipolar outputs full-bridge four-port converter based on phase-shift modulated buck–boost voltage balancer is proposed in this article. The interleaved bidirectional buck/boost circuit with pulsewidth modulation is used as the primary side to achieve the integration of renewable energy and energy storage, whereas the phase-shift modulated buck–boost voltage balancer is derived as a secondary side circuit to generate a symmetrical and common ground bipolar output voltage. Single-stage power conversion, symmetrical bipolar output voltage, approximately decoupled control loop, and soft switching can be realized in the proposed four-port converter. Detailed analysis of the proposed converter is presented, including operation principle, steady-state performance, soft switching performance, and control method. Finally, experimental verifications are carried out to illustrate the feasibility and effectiveness of the proposed topology.
18 November 2022 in IEEE Transactions on Power Electronics
Flexible power point tracking (FPPT) has been presented in the past years to control the output power of photovoltaic (PV) modules to a specific value, which makes PV generation much more friendly to the system. However, the tracking accuracy of existing FPPT algorithms is low during fast-changing irradiance. The improved FPPT algorithm, which consists of modified maximum power point tracking strategy and optimized constant power generation method, is proposed. Compared with existing FPPT algorithms, the tracking accuracy of the proposed algorithm for PV systems under various working conditions is improved while the energy difference is decreased. Followed by theoretical analysis, the simulation and experimental results validate the claimed advantages of the proposed solution.
23 March 2021 in IEEE Transactions on Industrial Electronics
A current sensor based global maximum power point tracking (GMPPT) algorithm of photovoltaic system is proposed in this article to increase the tracking speed during partial shading condition. For the proposed algorithm, the tracking range of duty cycle is reduced by calculating both the upper limit and lower limit of duty cycle and skipping the duty cycle section without global maximum power point. Compared with maximum power trapezium (MPT) algorithm and the combination algorithm of MPT and search-skip-judge, the proposed algorithm reduces the tracking range of duty cycle during both tracking directions and only needs one current sensor to realize control. As a result, the proposed algorithm shows advantages of fast tracking speed, small energy loss, and low hardware cost. Followed by theoretical analysis, the simulation and experimental evaluation validate the claimed advantages of the proposed GMPPT algorithm.
5 June 2023 in IEEE Transactions on Sustainable Energy
Global flexible power point tracking (GFPPT) is proposed to realize the flexible power point tracking (FPPT) of photovoltaic systems under partial shading conditions (PSC). Because the working process of GFPPT is similar to global power point tracking (GMPPT), the performance of GFPPT can be improved by applying the existing advanced GMPPT algorithm. However, the improvement of GFPPT is limited while applying the existing advanced GMPPT algorithm directly. So, a target-voltage-iterations (TVI) based GFPPT algorithm is proposed in this article to further increase the performance of GFPPT during PSC. Compared with the advanced GFPPT algorithms, the proposed TVI-based GFPPT algorithm shows the advantages of fast-tracking speed and little energy difference during the tracking by skipping the voltage section without the reference power. Followed by theoretical analysis, the simulation and experimental evaluation validate the claimed advantages of the proposed TVI-based GFPPT algorithm.
27 March 2026 in International Journal of Electrical Power & Energy Systems