6 April 2022 in IEEE Journal of Emerging and Selected Topics in Power Electronics
At present, single-stage wireless power transfer (WPT) resonant converter with boost bridgeless power-factor-correction (PFC) rectifier has not been promoted due to the rising voltage of dc-link and unstable output voltage of the converter. The compensation network with load-independent constant current output (CCO) and constant voltage output (CVO) characteristics cannot be analyzed in this converter due to the above problems. In order to solve these problems, a new asymmetric modulation method and the corresponding compensation network design method for single-stage WPT converter are proposed in this article. The proposed modulation method makes the voltage of dc link and the output voltage of single-stage WPT converter constant. Based on the new modulation method, the design method of the compensation network and the implementation of zero-voltage switching (ZVS) in single-stage WPT converter are proposed and analyzed in this article. Compared with the other WPT converters, the proposed scheme has advantages in efficiency and cost. Finally, the superiorities of the proposed circuit are verified by experiments.
3 May 2022 in IEEE Transactions on Vehicular Technology
Miniaturization and low cost contribute to the development and popularization of wireless power transfer (WPT). Reducing the number of power conversion stages can reduce the volume and cost of the WPT converter, and even make it possible to improve the efficiency. A single-stage WPT converter with constant current (CC) and constant voltage (CV) output and its asymmetric modulation method are proposed in this paper. A direct AC-AC converter is applied to the primary side of the WPT converter to directly convert line-frequency AC to high-frequency AC. The applied direct AC-AC converter that can replace the commonly used multi-stage primary converter reduces the number of circuit devices, thereby reducing the volume and cost of primary converter. The proposed WPT converter can realize zero voltage switching (ZVS) and power factor correction (PFC). In order to achieve CC and CV output, a switchable hybrid compensation topology is applied to the proposed WPT converter. A 720-W experimental prototype was manufactured to verify the rationality of the proposed WPT converter and the correctness of the theoretical analysis.