The article investigates the structural, optical, and electrical properties of silicon n+-p structures. The experimental samples were made from high-resistance single-crystal silicon using two-stage phosphorus diffusion from solid-state planar sources. It was found that the introduction of phosphorus impurities with a concentration of 1.2∙1020 cm-3 provokes the formation of dislocations with a surface density of 2∙103-3∙103 cm-2 due to the formation and relaxation of mechanical stresses. The formation of a lightening oxide film on the silicon surface reduces the reflection coefficient by 25%. However, the formation of an n+-layer reduces the transmittance coefficient of the structure. It was established from the voltage-current characteristics of the n+-p structure under forward and reverse voltage bias, that in the temperature range T = 295–346 K, these structures have rectifying properties. At room temperature, the height of the potential barrier is 0.6 eV and decreases with temperature and its height at 0 K is 1.32 еV. At low forward biases, the dominant mechanism of current transport in the structure is superbarrier emission. With an increase in forward voltage from 0.1 V to 0.6 V, the generation-recombination mechanism prevails, and with an increase in temperature, an increase in the contribution of tunnel current is observed. At low reverse voltages, the I-V characteristics of diodes are well described by the formula for the generation current. The depth of occurrence of donor energy levels, from which thermal generation of charge carriers occurs is 0.15 eV.
A combined method for the reduction of graphene oxide using simultaneous substrate heating while 455 nm CW laser irradiation was investigated. Using Raman spectroscopy, XPS, AFM and electrical measurements it was shown, that the mild thermal heating of the treated SiO2/Si substrate shifts the optimal regime down to 4 times lower CW laser treatment power.Strong correlation of Raman intensities ratio ID/(ID+IG) with electrical resistivity measurements was revealed and as it was shown, could be used to determine optimal CW laser power value in order to obtain high enough electrical conductivity with lack of structural defects. XPS analysis confirmed significantly lower percentage of oxygen containing groups ~15 at% for optimal regime of the combined laser treatment in air compared to a thermal annealing at 250ºC ~20 at%. AFM measurements demonstrate that CW laser treatment in air provides strongly heterogeneous surface of reduced graphene oxide film with burnt areas and folds.
We demonstrate that low-power magnetron plasma-enhanced chemical vapor deposition (PECVD) using methane–nitrogen working gas enables template-free direct deposition of nano-/meso-porous CNₓ coatings with tunable morphology. Depending on the cathode material (silicon or graphite), the degree of nitrogen incorporation, and post-deposition vacuum annealing, the coating morphology can be tailored from vertically aligned nanorods to sponge-like porous networks. CNₓ thin films with representative morphologies of aligned nanorods and sponge-like structures were subsequently loaded with platinum nanoparticles using chloroplatinic acid hydrate aqueous solution as a precursor, and evaluated as electrocatalytic surface layers for the hydrogen evolution reaction (HER) in water splitting. The sponge-like porous composite layer with Pt loading of approximately 0.02–0.03 mg cm⁻², exhibited electrocatalytic performance surpassing that of a flat Pt electrode. The high electrocatalytic efficiency at extra-low platinum loading is attributed to the combined effects of nitrogen doping, controlled hierarchical porosity, and graphitic connectivity, which together promote uniform Pt nanoparticles dispersion and enhanced charge transfer.