Divya Chalise

Divya Chalise

Auto-generated profile, based on publicly available information

Divya Chalise

Energy Storage and Distributed Resources Division, Lawrence Berkeley National Laboratory, Berkeley, USA

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2016 in Journal of Power Sources
Verified
Journal Article
Closed access
KSKrishna Shah
Krishna Shah
DCDivya Chalise
Divya Chalise
AJAnkur Jain
Ankur Jain

3 June 2023 in Nature Communications
Verified
Journal Article
Open access
PDF file
YZYuqiang Zeng
Yuqiang Zeng
BZBuyi Zhang
Buyi Zhang
YFYanbao Fu
Yanbao Fu
FSFengyu Shen
Fengyu Shen
QZQiye Zheng
Qiye Zheng
RPRavi S. Prasher
Ravi S. Prasher
The mass adoption of electric vehicles is hindered by the inadequate extreme fast charging (XFC) performance (i.e., less than 15 min charging time to reach 80% state of charge) of commercial high-specific-energy (i.e., >200 Wh/kg) lithium-ion batteries (LIBs). Here, to enable the XFC of commercial LIBs, we propose the regulation of the battery’s self-generated heat via active thermal switching. We demonstrate that retaining the heat during XFC with the switch OFF boosts the cell’s kinetics while dissipating the heat after XFC with the switch ON reduces detrimental reactions in the battery. Without modifying cell materials or structures, the proposed XFC approach enables reliable battery operation by applying <15 min of charge and 1 h of discharge. These results are almost identical regarding operativity for the same battery type tested applying a 1 h of charge and 1 h of discharge, thus, meeting the XFC targets set by the United States Department of Energy. Finally, we also demonstrate the feasibility of integrating the XFC approach in a commercial battery thermal management system.

1 October 2016 in Energy
Verified
Journal Article
Closed access
KSKrishna Shah
Krishna Shah
CMC. McKee
C. McKee
DCD. Chalise
D. Chalise
AJA. Jain
A. Jain

7 January 2020 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
DCDivya Chalise
Divya Chalise
WLWenquan Lu
Wenquan Lu
VSVenkat Srinivasan
Venkat Srinivasan
RPRavi Shankar Prasher
Ravi Shankar Prasher
Predicting temperature rise accurately during fast charge/discharge of a Li-ion cell is essential to avoid thermal runaway and extend battery life. While modeling the temperature rise, it is necessary to model the heat generation correctly. Heat of mixing, one of the four main sources of heat generation in a Li-ion battery, has often been considered insignificant and therefore excluded from modeling. When included, it is modeled using the expression from a Taylor expansion approximation. In this work, we have shown the conditions when including the heat of mixing becomes important and quantified the error associated with using the Taylor expansion, especially under high charge/discharge conditions. Consequently, we carry out the calculation of the rate of enthalpy change and the heat generation rate from the most fundamental equation for the rate of the total enthalpy change without simplifying assumptions or approximations. The heat generation rate calculated doing so naturally includes irreversible, reversible and mixing heat. We then exclusively separate out the heat of mixing by subtracting the rate of enthalpy change by reaction from the rate of the total enthalpy change. Results show that the contribution of heat of mixing in the total heat generated increases with the charge/discharge rate and is as large as 23% for a 6 C discharge. This result suggests that while modeling heat generation for fast charge/discharge, it is necessary to include the heat of mixing and avoid calculating it using the Taylor expansion approximation.

1 September 2017 in International Journal of Heat and Mass Transfer
Verified
Journal Article
Closed access
DCDivya Chalise
Divya Chalise
KSKrishna Shah
Krishna Shah
THTobias Halama
Tobias Halama
LKLidiya Komsiyska
Lidiya Komsiyska
AJAnkur Jain
Ankur Jain

28 November 2017 in Journal of Electrochemical Energy Conversion and Storage
Verified
Journal Article
Open access
PDF file
DCDivya Chalise
Divya Chalise
KSKrishna Shah
Krishna Shah
RPRavi Prasher
Ravi Prasher
AJAnkur Jain
Ankur Jain
Thermal management of Li-ion battery packs is a critical technological challenge that directly impacts safety and performance. Removal of heat generated in individual Li-ion cells into the ambient is a considerably complicated problem involving multiple heat transfer modes. This paper develops an iterative analytical technique to model conjugate heat transfer in coolant-based thermal management of a Li-ion battery pack. Solutions for the governing energy conservation equations for thermal conduction and convection are derived and coupled with each other in an iterative fashion to determine the final temperature distribution. The analytical model is used to investigate the dependence of the temperature field on various geometrical and material parameters. This work shows that the coolant flowrate required for effective cooling can be reduced significantly by improving the thermal conductivity of individual Li-ion cells. Further, this work helps understand key thermal–electrochemical trade-offs in the design of thermal management for Li-ion battery packs, such as the trade-off between temperature rise and energy storage density in the battery pack.