1 December 2022 in IEEE Transactions on Electron Devices
High-performance thin-film transistors (TFTs) with amorphous indium gallium zinc oxide (IGZO)/Ga $_\text{2}$ O $_\text{3}$ heterojunction and the reference TFTs with single-layer IGZO, Ga $_\text{2}$ O $_\text{3}$ , and stacked IGZO/Al $_\text{2}$ O $_\text{3}$ layers are fabricated by sputtering. The as-deposited IGZO/Ga $_\text{2}$ O $_\text{3}$ TFT shows high ON current of 0.97 $\mu $ A $\cdot$ $\mu $ m $^{-\text{1}}$ at a drain voltage of 1 V, which is $\text{7}$ orders of magnitude higher than that of the reference single layer TFTs and high mobility of 22.2 cm $^{\text{2}}{\cdot}$ V $^{-\text{1}}{\cdot}$ s $^{-\text{1}}$ , which is twice of that of the reference as-deposited IGZO/Al $_\text{2}$ O $_\text{3}$ TFT (11.5 cm $^{\text{2}}{\cdot}$ V $^{-\text{1}}{\cdot}$ s $^{-\text{1}}$ ). Combining such superior conductivity of the IGZO/Ga $_\text{2}$ O $_\text{3}$ TFT with the energy-level alignment, it indicates quasi-two-dimensional electron gas existed at the interface originated from the electrons confined in the potential well of IGZO. After annealing in air atmosphere, the IGZO/Ga $_\text{2}$ O $_\text{3}$ TFT shows an effective gate modulation with high current ON/OFF ratio of 1.2 $\times$ 10 $^{\text{7}}$ and high mobility of 15.8 cm $^{\text{2}}{\cdot}$ V $^{-\text{1}}\cdot$ s $^{-\text{1}}$ comparing with that of the reference annealed IGZO/Al $_\text{2}$ O $_\text{3}$ TFT (11.5 cm $^{\text{2}}{\cdot}$ V $^{-\text{1}}{\cdot}$ s $^{-\text{1}}$ ). In addition, the bias stability of the annealed IGZO/Ga $_\text{2}$ O $_\text{3}$ TFT is enhanced due to the interface passivation. Our results indicate that amorphous IGZO/Ga $_\text{2}$ O $_\text{3}$ heterostructure is an effective way to achieve high-mobility and stable TFTs, which have great potential in low-cost, large-area, and flexible high-definition displays.
20 September 2018 in IEEE Electron Device Letters
Oxide semiconductors are ideal candidates for flexible and transparent electronics. Here, we report complementary inverters based on p-type tin monoxide and n-type indium-gallium-zinc-oxide thin-film transistors. The inverters have a gain of 63 at a supply voltage, V DD , of 1.5 V with a maximum static power consumption of 15.6 nW, and a gain of 226 at V DD of 3.0 V with a maximum power consumption of 241.2 nW. A five-stage ring oscillator (RO) based on the complementary inverters is able to operate at 1.04 kHz with full amplitude oscillations at V DD of 1.5 V. All the inverters and RO are fabricated on silicon wafers but at a maximum processing temperature of 225 °C, so that the results are relevant to possible flexible applications. The extremely low power consumption of nanowatt, high gain, kHz operation, and possible flexibility of the fabricated complementary components is well suited to meet the requirements of wearable electronics, Internet of Things technology, and so on.
30 January 2023 in IEEE Electron Device Letters
Amorphous Ga2O3 (a-Ga2O3) thin-film phototransistors were fabricated by sputtering and achieved excellent solar-blind detection properties with superhigh responsivity of 2.0 $\times \,\,10^{{5}}\,\,\text{A}\cdot \text{W}^{-{1}}$ , ultrahigh detectivity of 4.9 $\times \,\,10^{{18}}$ Jones, high external quantum efficiency of 9.9 $\times \,\,10^{{7}}$ %, and high photo-to-dark current ratio of 2.9 $\times \,\,10^{{8}}$ . These values are considerably high compared with those of the reported a-Ga2O3 phototransistors, and are comparable to or even better than those of the reported high-performance crystalline $\beta $ -Ga2O3 phototransistors. A 10 $\times10$ a-Ga2O3 thin-film phototransistor array was fabricated, showing a clear “SDU” pattern with high contrast. In addition, the light control logic AND and OR gates based on a-Ga2O3 thin-film phototransistors were realized by utilizing two light spikes as logic input signals. Our work demonstrates that the a-Ga2O3 thin-film phototransistors have great potential in large area photosensitive circuits with high detection sensitivity and high signal-to-noise ratio.
16 November 2020 in IEEE Electron Device Letters
10 May 2021 in IEEE Electron Device Letters
P-type tin monoxide (SnO) thin-film phototransistors were developed with high photoresponsivity of 2.94×10 5 A/W and high detectivity of 1.82×10 14 Jones, and these values are, to the best of our knowledge, among the highest for the reported oxide-semiconductor-based phototransistors. The excellent performances of these phototransistors were further demonstrated by incorporating the devices into a 10×10 array to successfully image a letter “A” pattern. Furthermore, by integration of n-type indium gallium zinc oxide and p-type SnO thin-film phototransistors, we realized a complementary photosensitive inverter. The inverter exhibits excellent photoresponse with a high voltage gain rate change of 194%. Our results indicates that the SnO based phototransistors have great potential in thin-film photoelectronic circuits and systems.
23 October 2018 in IEEE Electron Device Letters
Static random access memory (SRAM) is essential for cache memory. Although oxide semiconductors are ideal candidate materials for next generation flexible electronics, complementary SRAM based on oxide semiconductors has not yet been demonstrated. Here, we reported an SRAM with a traditional 6-transistor structure based on n-type indium gallium zinc oxide and p-type tin monoxide. A cell area of only 130 × 160 μm2 has been achieved, and is the smallest among the reported values of SRAMs based on flexible semiconductors. Both traditional static voltage characteristic and N-curve methods are applied to analyse the noise margin level of the cell. The former method demonstrates a high noise margin of 1.43 V in read at VDD of 8 V, and the latter demonstrates static current and voltage noise margins of 13 μA and 2.05 V, respectively. In addition, the SRAM cell shows rather short writing time of 121 and 82 μs for high and low writing states, respectively. This high performance complementary SRAM based on all oxide semiconductors indicates its high application potential in large-scale flexible electronics for data storage and processing.