6 October 2020 in Astronomy & Astrophysics
TCthe GALAH Collaboration
+20
Massive sets of stellar spectroscopic observations are rapidly becoming available and these can be used to determine the chemical composition and evolution of the Galaxy with unprecedented precision. One of the major challenges in this endeavour involves constructing realistic models of stellar spectra with which to reliably determine stellar abundances. At present, large stellar surveys commonly use simplified models that assume that the stellar atmospheres are approximately in local thermodynamic equilibrium (LTE). To test and ultimately relax this assumption, we have performed non-LTE calculations for 13 different elements (H, Li, C, N, O, Na, Mg, Al, Si, K, Ca, Mn, and Ba), using recent model atoms that have physically-motivated descriptions for the inelastic collisions with neutral hydrogen, across a grid of 3756 1D MARCS model atmospheres that spans 3000 ≤ Teff∕K ≤ 8000, − 0.5 ≤log g∕cm s−2 ≤ 5.5, and − 5 ≤ [Fe/H] ≤ 1. We present the grids of departure coefficients that have been implemented into the GALAH DR3 analysis pipeline in order to complement the extant non-LTE grid for iron. We also present a detailed line-by-line re-analysis of 50 126 stars from GALAH DR3. We found that relaxing LTE can change the abundances by between − 0.7 dex and + 0.2 dex for different lines and stars. Taking departures from LTE into account can reduce the dispersion in the [A/Fe] versus [Fe/H] plane by up to 0.1 dex, and it can remove spurious differences between the dwarfs and giants by up to 0.2 dex. The resulting abundance slopes can thus be qualitatively different in non-LTE, possibly with important implications for the chemical evolution of our Galaxy. The grids of departure coefficients are publicly available and can be implemented into LTE pipelines to make the most of observational data sets from large spectroscopic surveys.
24 March 2020 in Astronomy & Astrophysics
Global magnetic fields of active solar-like stars are, nowadays, routinely detected with spectropolarimetric measurements and are mapped with Zeeman Doppler imaging (ZDI). However, due to the cancellation of opposite field polarities, polarimetry only captures a tiny fraction of the magnetic flux and cannot assess the overall stellar surface magnetic field if it is dominated by a small-scale component. The analysis of Zeeman broadening in high-resolution intensity spectra can reveal these hidden complex magnetic fields. Historically, there were very few attempts to obtain such measurements for G dwarf stars due to the difficulty of disentangling the Zeeman effect from other broadening mechanisms affecting spectral lines. Here, we developed a new magnetic field diagnostic method based on relative Zeeman intensification of optical atomic lines with different magnetic sensitivity. By using this technique, we obtained 78 field strength measurements for 15 Sun-like stars, including some of the best-studied young solar twins. We find that the average magnetic field strengthBfdrops from 1.3−2.0 kG in stars younger than about 120 Myr to 0.2−0.8 kG in older stars. The mean field strength shows a clear correlation with the Rossby number and with the coronal and chromospheric emission indicators. Our results suggest that magnetic regions have roughly the same local field strengthB ≈ 3.2 kG in all stars, with the filling factorfof these regions systematically increasing with stellar activity. In comparing our results with the spectropolarimetric analyses of global magnetic fields in the same stars, we find that ZDI recovers about 1% of the total magnetic field energy in the most active stars. This figure drops to just 0.01% for the least active targets.
23 March 2023 in Astronomy & Astrophysics
Context.The characterization of exoplanets requires the reliable determination of the fundamental parameters of their host stars. Spectral fitting plays an important role in this process. For the majority of stellar parameters, matching synthetic spectra to the observations provides a robust and unique solution for the fundamental parameters, such as effective temperature, surface gravity, abundances, radial and rotational velocities, among others.Aims.Here, we present a new software package for fitting high-resolution stellar spectra that is easy to use, available for common platforms, and free from commercial licenses. We call it PySME. It is based on the proven Spectroscopy Made Easy package, later referred to as IDL SME or “original” SME.Methods.The IDL (Interactive Data Language) part of the original SME code has been rewritten in Python, but we kept the efficient C++ and FORTRAN code responsible for molecular-ionization equilibrium, opacities, and spectral synthesis. In the process we updated some components of the optimization procedure to offer more flexibility and better analysis of the convergence. The result is a more modern package with the same functionality as the original SME.Results.We applied PySME to a few stars of different spectral types and compared the derived fundamental parameters with the results from IDL SME and other techniques. We show that PySME works at least as well as the original SME.
8 September 2022 in Astronomy & Astrophysics
Context. It is well known that cool star atmospheres depart from local thermodynamic equilibrium (LTE). Making an accurate abundance determination requires taking those effects into account, but the necessary non-LTE (hereafter NLTE) calculations are often lacking. Aims. Our goal is to provide detailed estimates of NLTE effects for FGK type stars for all spectral lines from the ultraviolet (UV) to the near infrared (NIR) that are potentially useful as abundance diagnostics. The first paper in this series focusses on the light elements Na, Mg, and Al. Methods. The code PySME was used to compute curves of growth for 2158 MARCS model atmospheres in the parameter range 3800 < Teff < 8000 K, 0.0 < log(g) < 5.5, and −5 < [Fe/H] < +0.5. Two microturbulence values, 1 and 2 kms−1, and nine abundance points spanning −1 < [X/Fe] < 1 for element X, are used to construct individual line curves of growth by calculating the equivalent widths of 35 Na lines, 134 Mg lines, and 34 Al lines. The lines were selected in the wavelength range between 2000 Å and 3 µm. Results. We demonstrate the power of the new grids with LTE and NLTE abundance analysis by means of equivalent width measurements of five benchmark stars; the Sun, Arcturus, HD 84937, HD 140283 and HD 122563. For Na, the NLTE abundances are lower than in LTE and show markedly reduced line-to-line scatter in the metal-poor stars. For Mg, we confirm previous reports of a significant ~0.25 dex LTE ionisation imbalance in metal-poor stars that is only slightly improved in NLTE (~0.18 dex). LTE abundances based on Mg II lines agree better with models of Galactic chemical evolution. For Al, NLTE calculations strongly reduce an ~0.6 dex ionisation imbalance seen in LTE for the metal-poor stars. The abundance corrections presented in this work are in good agreement with previous studies for the subset of lines that overlap, with the exception of strongly saturated lines. Conclusions. A consensus between different abundance diagnostics is the most powerful tool available to stellar spectroscopists to assess the accuracy of the models. Here we report that NLTE abundance analysis in general leads to improved agreement, in particular for metal-poor stars. The residual scatter is believed to be caused mainly by unresolved blends and/or poor atomic data, with the notable exception of Mg, which calls for further investigation.
2 February 2021 in Astronomy & Astrophysics
Context. The price of instruments and observing time on modern telescopes is quickly increasing. Therefore, it is worth revisiting the data reduction algorithms to extract every bit of scientific information from available observations. Echelle spectrographs are typical instruments used in high-resolution spectroscopy, but attempts to improve the wavelength coverage and versatility of these instruments has resulted in a complicated and variable footprint of the entrance slit projection onto the science detector. Traditional spectral extraction methods generally fail to perform a truly optimal extraction when the slit image is not aligned with the detector columns and, instead, is tilted or even curved. Aims. Here, we present the mathematical algorithms and examples of their application to the optimal extraction and the following reduction steps for echelle spectrometers equipped with an entrance slit that is imaged with various distortions. The new method minimises the loss of spectral resolution, maximises the signal-to-noise ratio, and efficiently identifies local outliers. In addition to the new optimal extraction, we present order splicing and a more robust continuum normalisation algorithm. Methods. We developed and implemented new algorithms that create a continuum-normalised spectrum. In the process, we account for the (variable) tilt or curvature of the slit image on the detector and achieve optimal extraction without prior assumptions about the slit illumination. Thus, the new method can handle arbitrary image slicers, slit scanning, and other observational techniques aimed at increasing the throughput or dynamic range. Results. We compare our methods with other techniques for different instruments to illustrate the superior performance of the new algorithms compared to commonly used procedures. Conclusions. Advanced modelling of the focal plane requires significant computational effort but it has proven worthwhile thanks to the retrieval of a greater store of science information from every observation. The described algorithms and tools are freely available as part of our PyReduce package.
18 July 2018 in The Astrophysical Journal
A star enshrouded in a Dyson sphere with a high covering fraction may manifest itself as an optically subluminous object with a spectrophotometric distance estimate significantly in excess of its parallax distance. Using this criterion, the Gaia mission will in coming years allow for Dyson sphere searches that are complementary to searches based on waste-heat signatures at infrared wavelengths. A limited search of this type is also possible at the current time, by combining Gaia parallax distances with spectrophotometric distances from ground-based surveys. Here, we discuss the merits and shortcomings of this technique and carry out a limited search for Dyson sphere candidates in the sample of stars common to Gaia Data Release 1 and Radial Velocity Experiment (RAVE) Data Release 5. We find that a small fraction of stars indeed display distance discrepancies of the type expected for nearly complete Dyson spheres. To shed light on the properties of objects in this outlier population, we present follow-up high-resolution spectroscopy for one of these stars, the late F-type dwarf TYC 6111-1162-1. The spectrophotometric distance of this object is about twice that derived from its Gaia parallax, and there is no detectable infrared excess. While our analysis largely confirms the stellar parameters and the spectrophotometric distance inferred by RAVE, a plausible explanation for the discrepant distance estimates of this object is that the astrometric solution has been compromised by an unseen binary companion, possibly a rather massive white dwarf (≈1 M ⊙). This scenario can be further tested through upcoming Gaia data releases.