1 January 1984 in IEEE Transactions on Electron Devices
A new and accurate approach to charge-pumping measurements for the determination of the Si-SiO2interface state density directly on MOS transistors is presented. By a careful analysis of the different processes of emission of electrons towards the conduction band and of holes towards the valence band, depending on the charge state of the interface, all the previously ill-understood phenomena can be explained and the deviations from the simple charge-pumping theory can be accounted for. The presence of a geometric component in some transistor configurations is illustrated and the influence of trapping time constants is discussed. Furthermore, based on this insight, a new technique is developed for the determination of the energy distribution of interface states in small-area transistors, without requiring the knowledge of the surface potential dependence on gate voltage.
1 April 1998 in IEEE Transactions on Electron Devices
In this paper it is demonstrated in a wide stress field range that breakdown in thin oxide layers occurs as soon as a critical density of neutral electron traps in the oxide is reached. It is proven that this corresponds to a critical hole fluence, since a unique relationship between electron trap generation and hole fluence is found independent of stress field and oxide thickness. In this way literature models relating breakdown to hole fluence or to trap generation are linked. A new model for intrinsic breakdown, based on a percolation concept, is proposed. It is shown that this model can explain the experimentally observed statistical features of the breakdown distribution, such as the increasing spread of the Q/sub BD/-distribution for ultrathin oxides. An important consequence of this large spread is the strong area dependence of the Q/sub BD/ for ultrathin oxides.
7 December 2011 in IEEE Transactions on Electron Devices
Germanium is a widely used material for tunnel FETs because of its small band gap and compatibility with silicon. Typically, only the indirect band gap of Ge at 0.66 eV is considered. However, direct band-to-band tunneling (BTBT) in Ge should be included in tunnel FET modeling and simulations since the energy difference between the Ge conduction band edges at the L and Γ valleys is only 0.14 eV at room temperature. In this paper, we theoretically calculate the parameters A and B of Kane's direct and indirect BTBT models at different tunneling directions ([100], [110], and [111]) for Si, Ge and unstrained Si1-xGex. We highlight how the direct BTBT component becomes more important as the Ge mole fraction increases. The calculation of the band-to-band generation rate in the uniform electric field limit reveals that direct tunneling always dominates over indirect tunneling in Ge. The impact of the direct transition in Ge on the performance of two realistic tunnel field-effect transistor configurations is illustrated with TCAD simulations. The influence of field-induced quantum confinement is included in the analysis based on a back-of-the-envelope calculation.
30 July 2007 in Applied Physics Letters
Tunnel field-effect transistors are promising successors of metal-oxide-semiconductor field-effect transistors because of the absence of short-channel effects and of a subthreshold-slope limit. However, the tunnel devices are ambipolar and, depending on device material properties, they may have low on-currents resulting in low switching speed. The authors have generalized the tunnel field-effect transistor configuration by allowing a shorter gate structure. The proposed device is especially attractive for vertical nanowire-based transistors. As illustrated with device simulations, the authors’ more flexible configuration allows of the reduction of ambipolar behavior, the increase of switching speed, and the decrease of processing complexity.
1 July 1989 in IEEE Transactions on Electron Devices
1 January 1988 in IEEE Transactions on Electron Devices