Yuan Chen

Yuan Chen

Auto-generated profile, based on publicly available information

Yuan Chen

The School of Optoelectronic Science and Engineering, University of Electronic Science and Technology of China, Chengdu 610054, China

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 December 2023 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
YCYuan Chen
Yuan Chen
Zhiqiang FanZhiqiang Fan
Zhiqiang Fan
YYYang Yang
Yang Yang
YLYue Lin
Yue Lin
DJDi Jiang
Di Jiang
QQQi Qiu
Qi Qiu
High-Q silicon nitride microdisk resonators (MDRs) with fewer resonant modes are proposed and experimentally demonstrated. The proposed MDRs consist of microdisks and optimized bent bus waveguides. The introduction of asymmetric directional couplers (DCs) successfully destroys part of high-order modes resonance and enhances that of TE1 and TE2 radial modes so that the spectral purity of the MDRs is improved. In this way, guided-modes propagate in MDRs with low loss and > 106 Q-factors are obtained. The maximum measured loaded Q-factor and intrinsic Q-factor is $4.7\times 10 ^{6}$ and $5.9\times 10 ^{6}$ , respectively. The minimum wavelength interval between two notches is 0.68 nm. The proposed few-mode MDRs are realized with one step silicon nitride etching process provided by a multiproject wafer foundry and they have broad application prospects in integrated microwave photonic systems, sensing, and other fields.

18 January 2023 in IEEE Photonics Journal
Verified
Journal Article
Open access
YCYuan Chen
Yuan Chen
Zhiqiang FanZhiqiang Fan
Zhiqiang Fan
YLYue Lin
Yue Lin
DJDi Jiang
Di Jiang
XLXiang Li
Xiang Li
QQQi Qiu
Qi Qiu
A bandwidth-tunable multiband microwave photonic filter (MPF) using a strongly coupled microring resonator (MRR) with optical phase modulation is demonstrated theoretically and experimentally. Two notches of the MRR adjacent to the optical carrier break the intrinsic balance of the phase-modulated signal and then two sub-MPFs are formed thanks to the conversion from phase modulation to intensity modulation (PM-IM). The frequency responses of the two sub-MPFs are superimposed to form a passband with a fixed center frequency. Due to the periodicity of the MRR transmission spectrum, multiple passbands separated by a certain spacing appear in the frequency domain and combine to form a multiband MPF, whose bandwidth can be adjusted by tuning the wavelength of the carrier. The tunable bandwidth and shape factors ranging from 0.73GHz to 2.73GHz and 5.06 to 1.38 are experimentally performed. The number of passbands can be reconfigured. The proposed multiband MPF has the potential to be employed in modern multi-standard wireless communication systems.

3 January 2024 in Applied Optics
Verified
Journal Article
Closed access
YCYuan Chen
Yuan Chen
Zhiqiang FanZhiqiang Fan
Zhiqiang Fan
QQQi Qiu
Qi Qiu
Due to the gain competition effect, it is hard to simultaneously maintain oscillation at two frequencies in an optoelectronic oscillator (OEO) loop. In this paper, a study of the gain competition effect in a dual-frequency OEO is theoretically and experimentally demonstrated. The steady-state conditions in the dual-frequency OEO are theoretically analyzed by deriving dynamic equations. A nonlinear time-varying model, as well as its calculation methods, is carried out to design and study the dynamic process of the dual-frequency OEO. Thanks to this model, the waveform, spectrum, and amplitude evaluation of generated signals, as well as the gain variation in the OEO loop, are numerically simulated. Based on the theoretical analysis and numerical simulation results, three schemes that can suppress the gain competition effect are proposed, and the one based on wavelength division multiplexing (WDM) technology is experimentally realized. The experimental results show that the novel independently tunable dual-frequency OEO, to the best of our knowledge, can generate two-tone RF signals in a range from 1.8 to 18.6 and 1.5 to 18.3 GHz, respectively.

7 January 2024 in Photonics
Verified
Journal Article
Open access
PDF file
YLYue Lin
Yue Lin
DJDi Jiang
Di Jiang
YCYuan Chen
Yuan Chen
XLXiang Li
Xiang Li
QQQi Qiu
Qi Qiu
Optical beamforming in microwave photonics is promising for supporting broadband wireless communications. However, the current optical beamforming lacks freedom because of the fixed connection between radio frequency (RF) signal and antenna elements (AEs). This manuscript tackles this challenge by proposing a dynamical optical beamforming architecture that reconfigures the antenna subarray for signal transmission depending on the number of signals to be transmitted. The proposed architecture employs an optical switching and distributing network (SDN) to realize a flexible connection between signals and AEs. An instance of the proposed architecture in photonic integrated circuits, which enables three working modes and transmits four RF signals through sixteen AEs, was presented and numerically simulated. The optical field distribution and beam pattern plots illustrated the operational principle and validated the feasibility of the proposed SDN architecture. Furthermore, the impact of the introduced architecture on the signal amplitude–phase consistency and the comparison of the proposed dynamic architecture and conventional fixe architectures are analyzed and discussed. The results indicate that the proposed architecture exhibits variable beamforming gain with lower hardware complexity.

20 January 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
YLYue Lin
Yue Lin
JSJun Su
Jun Su
QQQi Qiu
Qi Qiu
Zhiqiang FanZhiqiang Fan
Zhiqiang Fan
SSShuangjin Shi
Shuangjin Shi
XLXiang Li
Xiang Li
A novel multi-beam photonic receiver with a variable beam count has been proposed. The reconfigurable characteristic of the system is enabled with the variable splitters and optical switch arrays. According to the number of beams it is due to receive, the splitter with suitable ports is chosen to split by controlling the optical switch in order to configure the optical path. After splitting, the multi-wavelength optical carriers are sent to the wavelength division multiplexer to combine and complete the multi-beamforming process. Two structures have been designed to realize the reconfigurable function, while the optimized structure is proved by using several benchmarks for comparison. The operation step of the reconfigurable multi-beam receiver is then given. The first simulations validate that the proposed architecture can dynamically receive the multi-beam with a variable number by reconfiguring the state of the optical switch. The second simulation of the influence on the received beam pattern was performed under a different amplitude and phase inconsistency random values. The results show that the amplitude and phase inconsistency will decline the quality of the multi-beam. When the amplitude and phase inconsistency are within limits, the difference in the optical path within the outputs must be balanced and compensated during the proposed system’s fabrication and deployment.

1 August 2019
Verified
Conference Paper
Closed access
YCYuan Chen
Yuan Chen
PZPeng Zhang
Peng Zhang
BHBo Hou
Bo Hou
Hong-Zhong HuangHong-Zhong Huang
Hong-Zhong Huang
Power devices are widely used in power supply or converter systems in aerospace, rail transit, smart grid, new energy vehicles, industrial electronics and other fields. The reliability of power devices plays an important role in the smooth operation of power electronic system. Junction temperature is an important parameter that determines the lifetime of power devices, and its fluctuation is directly related to the aging and failure of bonding wire and solder layer. In this paper, the NPN high-power switch transistor is tested for power cycling, and the changes of electrical parameters and thermal resistance are compared under different junction temperature variations, and Coffin-Mason model is used to predict its lifetime. The degradation trend of power devices is described by using both life prediction model and sensitive parameter change innovatively. The results show that the prediction lifetime by Coffin-Mason model is consistent with the degradation trend of sensitive parameters.