Monolayer transition metal dichalcogenides (TMDs) are direct gap semiconductors with promising applications in diverse optoelectronic devices. To improve devices’ performance, recent investigations have been systematically focused on the tuning of their optical properties. However, an all-optical approach with the reversible feature is still a challenge. Here we demonstrate the tunability of the photoluminescence (PL) properties of monolayer WS2 via laser irradiation. The broad-range and continuous modulation of PL intensity, as well as the conversion between neutral and charged excitons have been readily and reversibly achieved by only switching the two laser power densities. We attribute the reversible manipulation to the laser-assisted adsorption and desorption of gas molecules, which will deplete or release free electrons from the surface of WS2 and thus modify its PL properties. This all-optical manipulation, with advantages of reversibility, quantitative control, and high spatial resolution, suggests promising applications of TMDs monolayers in optoelectronic and nanophotonic applications, such as erasable optical data storage, micropatterning, and display.
A novel, intensity-stabilized, fast-scanned, direct absorption spectroscopy (IS-FS-DAS) instrumentation, based on a distributed feedback (DFB) diode laser, is developed. A fiber-coupled polarization rotator and a fiber-coupled polarizer are used to stabilize the intensity of the laser, which significantly reduces its relative intensity noise (RIN). The influence of white noise is reduced by fast scanning over the spectral feature (at 1 kHz), followed by averaging. By combining these two noise-reducing techniques, it is demonstrated that direct absorption spectroscopy (DAS) can be swiftly performed down to a limit of detection (LOD) (1σ) of 4 × 10−6, which opens up a number of new applications.
The achievement of size uniformity and monodispersity in perovskite quantum dots (QDs) requires the implementation of precise temperature control and the establishment of optimal reaction conditions. Nevertheless, the accurate control of a range of reaction variables represents a considerable challenge. This study addresses the aforementioned challenge by employing manganese (Mn) doping to achieve size uniformity in CsPbBr3 perovskite QDs without the necessity for precise control of the reaction conditions. By optimizing the Mn:Pb ratio, it is possible to successfully dope CsPbBr3 QDs with appropriate concentrations of Mn²⁺ and achieve a uniform size distribution. The spectroscopic measurements on single QDs indicate that the appropriate Mn²⁺ concentrations can result in a narrower spectral linewidth, a longer photoluminescence (PL) lifetime, and a reduced biexciton Auger recombination rate, thus positively affecting the PL properties. This study not only simplifies the size control of perovskite QDs, but also demonstrates the potential of Mn-doped CsPbBr3 QDs for narrow linewidth light-emitting diode applications.
Detection of trace gases with high sensitivity and weak excitation power is highly desired for long-range remote sensing. Here, we report the detection of the greenhouse gas nitrous oxide (N2O) with the power of excitation light down to picowatts, by converting the mid-infrared laser to near-infrared photons through an intra-cavity-enhanced sum-frequency upconversion system. The intra-cavity-enhanced pumping power of 1064.0 nm reaches about 200.0 W, resulting in the conversion of the 4514.6 nm mid-infrared laser to 861.1 nm with an efficiency up to 73.4% under optimal conditions. The upconverted light is then detected by a single-photon avalanche detector, followed by a time-correlated single-photon counting module, which can measure the arrival time of each upconverted photon. By performing discrete Fourier transformations of the arrival time of the detected photons, the frequency spectrum can be determined. By using frequency modulation, this method can suppress background noise significantly. Consequently, the excitation power can be brought down to about 100 pW with the concentration of N2O being 10 ppm. As a demonstration of application, the presented system is also used for N2O sensing in an open-path geometry, highlighting the potential for stand-off leak detection. Our proposal offers promising applications to monitor trace gases over long distances with weak excitation powers.