The growing demand for extensive and reliable structural health monitoring resulted in the development of advanced optical sensing systems (OSS) that in conjunction with wireless optical networks (WON) are capable of extending the reach of optical sensing to places where fibre provision is not feasible. To support this effort, the paper proposes a new type of a variable weight code called multiweight zero cross-correlation (MW-ZCC) code for its application in wireless optical networks based optical code division multiple access (WON-OCDMA). The code provides improved quality of service (QoS) and better support for simultaneous transmission of video surveillance, comms and sensor data by reducing the impact of multiple access interference (MAI). The MW-ZCC code’s power of two code-weight properties provide enhanced support for the needed service differentiation provisioning. The performance of this novel code has been studied by simulations. This investigation revealed that for a minimum allowable bit error rate of , and when supporting triple-play services (sensing, datacomms and video surveillance, respectively), the proposed WON-OCDMA using MW-ZCC codes could support up to 32 simultaneous services over transmission distances up to 32 km in the presence of moderate atmospheric turbulence.
This paper compares the efficiency of on-off Keying (OOK) modulation formats non-return-to-zero (NRZ) and return-to-zero (RZ) in both electrical and optical chromatic dispersion compensation. While In electrical compensator feed forward-decision feedback equalizer (FFE-DFE) method was applied, Dispersion Compensation Fiber (DCF) was chosen to evaluate the effect of modulation format on them. Transmission distance, subsequently are varied in both systems with mentioned compensation systems to evaluate the Bit Error Rate (BER) regarding to mentioned modulation techniques.
In this paper, we investigate the performance of an OCDMA system with ring topology where number of the spans can be more than one. Effect of circulation noise is evaluated beside of shot noise and thermal noise. Through analytical approach, it is shown that higher amount of amplifier gain, produces higher amount of circulation noise. Also by increasing the number of nodes, the strength of the circulation noise is reduced and the ratio of this reduction is more for lower amplifier gain. For example, with increasing number of the nodes from 3 to 8, the amount of log variance of circulation noise increases only 1 unit (-13 to -14) for amplifier gain 20 dBm, while this value is 4 units (from -15 to -19) if gain is 10 dBm.