12 April 2023 in Green Chemistry
This work demonstrates that reductive catalytic fractionation can be a feedstock-agnostic process on hardwoods, softwoods, agricultural residues, and grasses, especially with water-alcohol solvent mixtures.
14 September 2016 in Biotechnology Journal
Thioacidolysis is a method used to measure the relative content of lignin monomers bound by β‐O‐4 linkages. Current thioacidolysis methods are low‐throughput as they require tedious steps for reaction product concentration prior to analysis using standard GC methods. A quantitative thioacidolysis method that is accessible with general laboratory equipment and uses a non‐chlorinated organic solvent and is tailored for higher‐throughput analysis is reported. The method utilizes lignin arylglycerol monomer standards for calibration, requires 1–2 mg of biomass per assay and has been quantified using fast‐GC techniques including a Low Thermal Mass Modular Accelerated Column Heater (LTM MACH). Cumbersome steps, including standard purification, sample concentrating and drying have been eliminated to help aid in consecutive day‐to‐day analyses needed to sustain a high sample throughput for large screening experiments without the loss of quantitation accuracy. The method reported in this manuscript has been quantitatively validated against a commonly used thioacidolysis method and across two different research sites with three common biomass varieties to represent hardwoods, softwoods, and grasses.
26 October 2022 in Green Chemistry
When excess base is required to drive desired reactions, such as in lignin alkaline oxidation, Sr(OH)2 can offer a reversibly-soluble alternative to NaOH that allows simple recycle of the excess base with concomitant cost and environmental benefits.
5 October 2020 in Biofuels, Bioproducts and Biorefining
To achieve a bio‐based economy, it is necessary to consider variability within a feedstock population. We must understand the range of key phenotypic characteristics when selecting economically advantageous genotypes for domestication in an optimized supply chain. In this analysis we measured cell‐wall composition traits in a large natural variant population of Populus trichocarpa. The results were combined with agronomic growth data from the matching genotype to conduct various techno‐economic analyses, evaluating the impacts of physical and compositional variability and determining the ultimate phenotypic drivers for yield and economic metrics. Here we show that, although ethanol yield per land area per year and minimum fuel selling price were most strongly impacted by tree size, when considering the largest 25% of trees, size and carbohydrate content were nearly identical influences on minimal fuel selling price, highlighting the need to focus on both size and carbohydrate content in selecting economically optimal feedstocks. © 2020 The Authors. Biofuels, Bioproducts, and Biorefining published by Society of Chemical Industry and John Wiley & Sons, Ltd
30 March 2022 in Green Chemistry
Lignin is an abundant renewable resource that is a promising substrate for upgrading to fuels and chemicals. However, lignin-rich biorefinery streams are often physically and chemically complex, and could benefit substantially from fractionation. In this work, a membrane process was developed to fractionate low molecular weight (LMW) lignin-related compounds (molecular weight (MW) < 1000 Da) from a lignin-rich, alkaline pretreated liquor (APL) prepared from pretreatment of corn stover with NaOH. The developed membrane process exhibits up to 98.5% rejection of high molecular weight (HMW) (MW > 1000 Da) species and generates a permeate stream with >80% recovery of LMW lignin-related compounds including aromatic species such as p-coumarate and ferulate, resulting in a 6-fold enrichment in LMW organic compounds relative to the crude APL. Experimental batch data were used to develop a detailed process model of an industrial scale, continuous membrane filtration system. The open-source model has several independent process inputs, such as the concentration of target compounds, feed flow rate, volume recovery, and membrane selectivity. This process model was used to show that the system has a low estimated energy demand (0.75 kW h m−3 permeate) and was used to identify primary cost drivers, including the membrane material cost. These results offer a key step towards a scalable, low energy, and cost-effective lignin MW fractionation method with implications for both improving product isolation from lignin and improving carbon yields across the biorefinery.
21 August 2024 in New Phytologist
Summary: Our study utilized genome‐wide association studies (GWAS) to link nucleotide variants to traits in Populus trichocarpa, a species with rapid linkage disequilibrium decay. The aim was to overcome the challenge of interpreting statistical associations at individual loci without sufficient biological context, which often leads to reliance solely on gene annotations from unrelated model organisms. We employed an integrative approach that included GWAS targeting multiple traits using three individual techniques for lignocellulose phenotyping, expression quantitative trait loci (eQTL) analysis to construct transcriptional regulatory networks around each candidate locus and co‐expression analysis to provide biological context for these networks, using lignocellulose biosynthesis in Populus trichocarpa as a case study. The research identified three candidate genes potentially involved in lignocellulose formation, including one previously recognized gene (Potri.005G116800/VND1, a critical regulator of secondary cell wall formation) and two genes (Potri.012G130000/AtSAP9 and Potri.004G202900/BIC1) with newly identified putative roles in lignocellulose biosynthesis. Our integrative approach offers a framework for providing biological context to loci associated with trait variation, facilitating the discovery of new genes and regulatory networks.