The paper presents the results of an investigation into thin single- and triple-layer ZrO2-Sc2O3-based electrolytes prepared using the tape-casting technique in combination with promising electrodes based on La2NiO4+δ and Ni-Ce0.8Sm0.2O2-δ materials. It is shown that pressing and joint sintering of single electrolyte layers allows multilayer structures to be obtained that are free of defects at the layer interface. Electrical conductivity measurements of a triple-layer electrolyte carried out in longitudinal and transverse directions with both direct and alternating current showed resistance of the interface between the layers on the total resistance of the electrolyte to be minimal. Long-term tests have shown that the greatest degradation in resistance over time occurs in the case of an electrolyte with a tetragonal structure. Symmetrical electrochemical cells with electrodes fabricated using a screen-printing method were examined by means of electrochemical impedance spectroscopy. The polarization resistance of the electrodes was 0.45 and 0.16 Ohm∙cm2 at 800 °C for the fuel and oxygen electrodes, respectively. The distribution of relaxation times method was applied for impedance data analysis. During tests of a single solid oxide fuel cell comprising a supporting triple-layer electrolyte having a thickness of 300 microns, a power density of about 160 mW/cm2 at 850 °C was obtained using wet hydrogen as fuel and air as an oxidizing gas.
14 April 2021 in Journal of Solid State Electrochemistry
A continuous quasi-equilibrium phase diagram δ(pO2, T) of a nonstoichiometric oxide La2NiO4 + δ with the layered perovskite-like Ruddlesden–Popper structure is obtained by the method of quasi-equilibrium oxygen release. The thermodynamic parameters are determined as a function of the oxide nonstoichiometry δ. Calculations are carried out within the framework of the localized-electron and itinerant-electron models which are used for description of the defect structure of ferrites and cobaltites, respectively. It is shown that the specific features of the phase diagram can be related to the electronic density of states near the Fermi level.
17 July 2026 in Journal of Solid State Electrochemistry
A continuous phase diagram δ (pO2, T) of a nonstoichiometric oxide La2NiO4+δ with a layered perovskite-related Ruddlesden-Popper structure was obtained by the method of quasi-equilibrium oxygen release. The thermodynamic parameters are determined as functions of oxide nonstoichiometry δ. The calculation was carried out within the framework of the models of a localized electron and a free electron, which are used to describe the defect structure of ferrites and cobaltites, respectively. It is shown that the features of the phase diagram can be related to the density of electronic states near the Fermi level of electrons.
12 August 2024 in Химия в интересах устойчивого развития
A mathematical model of the flow of hydrogen from gas mixtures through the walls of capillary tubes made of metallic nickel has been developed, taking into account the inhomogeneity of the partial pressure of hydrogen along a long tube, as well as temperature nonuniformity in different regions of the tube. Using the model and relying on experimental data, the kinetic parameters of hydrogen transport were calculated within the temperature range of 600-850 °С and the hydrogen partial pressure range of 0.3-0.8 atm. The model can be used in the design of membrane modules for hydrogen separation from gas mixtures to calculate the length of individual membranes, their number, and the optimal flow rate of the hydrogen-containing gas mixture through the membrane.