Yang Yi

Yang Yi

Auto-generated profile, based on publicly available information

Yang Yi

School of Remote Sensing and Information Engineering, Wuhan University, Wuhan 430072, China

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 January 2021 in Journal of Geophysical Research: Atmospheres
Verified
Journal Article
Open access
PDF file
YHYun He
Yun He
FYFan Yi
Fan Yi
YYYang Yi
Yang Yi
FLFuchao Liu
Fuchao Liu
YZYunpeng Zhang
Yunpeng Zhang
Midlevel cloud layers (2–7 km) pertinent to transported Asian dust layers were observed on 26 occasions from the polarization lidar measurements during the period from December 2012 to December 2013 over Wuhan (30.5°N, 114.4°E), China. The events mainly occurred in winter. Cloud layers were mostly detected (19 out of 26) on top of the aloft Asian dust layers. The boundary between cloud layer and dust layer appeared at altitudes of 4–7 km. The observed events are classified into three categories: (1) category A (6 cases), supercooled liquid cloud layers persistently existed without an evident sign of freezing; (2) category B (9 cases), supercooled liquid cloud appeared initially and then ice crystals formed on the boundary between the cloud layer and dust layer; (3) category C (11 cases), only a cloud containing ice crystals was present throughout while the pure liquid stage did not present previously, indicating that deposition nucleation might take place. Cloud top temperatures (CTTs) for heterogeneous ice formation ranged from −38.5°C to −18.3°C; no ice formation occurred with CTT warmer than −15°C. After thousands of kilometers transport, ice nucleation efficiency of Asian dust over Wuhan substantially did not present a distinct change compared with that of pure dust.

9 March 2022 in Journal of Geophysical Research: Atmospheres
Verified
Journal Article
Closed access
YHYun He
Yun He
FYFan Yi
Fan Yi
FLFuchao Liu
Fuchao Liu
ZYZhenping Yin
Zhenping Yin
YYYang Yi
Yang Yi
YZYunpeng Zhang
Yunpeng Zhang

2 September 2021 in Atmospheric Measurement Techniques
Verified
Journal Article
Open access
PDF file
YHYun He
Yun He
YZYunfei Zhang
Yunfei Zhang
FLFuchao Liu
Fuchao Liu
ZYZhenping Yin
Zhenping Yin
YYYang Yi
Yang Yi
FYFan Yi
Fan Yi
The POLIPHON (polarization lidar photometer networking) method is a powerful pathway to retrieve the height profiles of dust-related particle mass and ice-nucleating particle (INP) concentrations. The conversion factors fitted from the sun photometer observation data are the major part of the POLIPHON computations, which can convert the polarization-lidar-derived dust extinction coefficients into dust-related particle mass and INP concentrations. For the central Chinese megacity of Wuhan (30.5∘ N, 114.4∘ E), located at the downstream area several thousands of kilometers far away from the source regions of Asian dust, dust particles always mix with other aerosols from local emissions. Therefore, very few dust case data sets can be available when using the column-integrated Ångström exponent (for 440–870 nm) <0.3 and aerosol optical depth (at 532 nm) >0.1 recorded by a sun photometer as the filtering criteria. Instead, we present another dust case data set screening scheme that applies the simultaneous polarization lidar observation to verify the occurrence of dust. Based on the 33 dust-intrusion days identified during 2011–2013, the extinction-to-volume (cv,d) and extinction-to-large particle (with radius >250 nm) number concentration (c250,d) conversion factors are determined to be (0.52±0.12)×10-12Mmm3m-3 and 0.19±0.05 Mm cm−3, respectively. The c250,d for Wuhan is 27 % larger than that observed at Lanzhou SACOL (36.0∘ N, 104.1∘ E), a site closer to the Gobi Desert, and tends to be closer to those observed in North Africa and the Middle East, indicating dust aerosols from these two sources are also possibly involved in the dust events observed over Wuhan. As a comparison, the conversion factor c290,c of 0.11±0.02Mmcm-3 for continental aerosol is much smaller than c250,d, indicating that there is no significant influence of urban aerosols on the retrievals of dust-related conversion factor over Wuhan. The conversion factors are applied in a dust event in Wuhan to reveal the typical dust-related immersion-mode INP concentration over East Asian cities. The proposed dust case data set screening scheme may potentially be extended to the other polluted city sites that are more influenced by mixed dust.

3 December 2021 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
YYYang Yi
Yang Yi
FYFan Yi
Fan Yi
FLFuchao Liu
Fuchao Liu
YZYunpeng Zhang
Yunpeng Zhang
CYChangming Yu
Changming Yu
YHYun He
Yun He
Mid-level stratiform precipitations during the passage of warm fronts were detailedly observed on two occasions (light and moderate rain) by a 355 nm polarization lidar and water vapor Raman lidar, both equipped with waterproof transparent roof windows. The hours-long precipitation streaks shown in the lidar signal (X) and volume depolarization ratio (δv) reveal some ubiquitous features of the microphysical process of precipitating hydrometeors. We find that for the light-rain case precipitation that reaches the surface begins as ice-phase-dominant hydrometeors that fall out of a shallow liquid cloud layer at altitudes above the 0 ∘C isotherm level, and the depolarization ratio magnitude of falling hydrometeors increases from the liquid-water values (δv<0.09) to the ice/snow values (δv>0.20) during the first 100–200 m of their descent. Subsequently, the falling hydrometeors yield a dense layer with an ice/snow bright band occurring above and a liquid-water bright band occurring below (separated by a lidar dark band) as a result of crossing the 0 ∘C level. The ice/snow bright band might be a manifestation of local hydrometeor accumulation. Most falling raindrops shrink or vanish in the liquid-water bright band due to evaporation, whereas a few large raindrops fall out of the layer. We also find that a prominent δv peak (0.10–0.40) always occurs at an altitude of approximately 0.6 km when precipitation reaches the surface, reflecting the collision–coalescence growth of falling large raindrops and their subsequent spontaneous breakup. The microphysical process (at ice-bright-band altitudes and below) of moderate rain resembles that of the light-rain case, but more large-sized hydrometeors are involved.

1 March 2021 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
FLFuchao Liu
Fuchao Liu
FYFan Yi
Fan Yi
ZYZhenping Yin
Zhenping Yin
YZYunpeng Zhang
Yunpeng Zhang
YHYun He
Yun He
YYYang Yi
Yang Yi
Knowledge of the convective boundary layer (CBL) and associated entrainment zone (EZ) is important for understanding land–atmosphere interactions and assessing the living conditions in the biosphere. A tilted 532 nm polarization lidar (30∘ off zenith) has been used for the routine atmospheric measurements with 10 s time and 6.5 m height resolution over Wuhan (30.5∘ N, 114.4∘ E). From lidar-retrieved aerosol backscatter, instantaneous atmospheric boundary layer (ABL) depths are obtained using the logarithm gradient method and Harr wavelet transform method, while hourly mean ABL depths are obtained using the variance method. A new approach utilizing the full width at half maximum of the variance profile of aerosol backscatter ratio fluctuations is proposed to determine the entrainment zone thickness (EZT). Four typical clear-day observational cases in different seasons are presented. The CBL evolution is described and studied in four developing stages (formation, growth, quasi-stationary and decay); the instantaneous CBL depths exhibited different fluctuation magnitudes in the four stages and fluctuations at the growth stage were generally larger. The EZT is investigated for the same statistical time interval of 09:00–19:00 LT. It is found that the winter and late autumn cases had an overall smaller mean (mean) and standard deviation (SD) of EZT data compared to those of the late spring and early autumn cases. This statistical conclusion was also true for each of the four developing stages. In addition, compared to those of the late spring and early autumn cases, the winter and late autumn cases had larger percentages of EZT falling into the subranges of 0–50 m but smaller percentages of EZT falling into the subranges of > 150 m. It seems that both the EZT statistics (mean and SD) and percentage of larger EZT values provide measures of entrainment intensity. Common statistical characteristics also existed. All four cases showed moderate variations of the mean of the EZT from stage to stage. The growth stage always had the largest mean and SD of the EZT and the quasi-stationary stage usually the smallest SD of the EZT. For all four stages, most EZT values fell into the 50–150 m subrange; the overall percentage of the EZT falling into the 50–150 m subrange between 09:00 and 19:00 LT was > 67 % for all four cases. We believe that the lidar-derived characteristics of the clear-day CBL and associated EZ can contribute to improving our understanding of the structures and variations of the CBL as well as providing a quantitatively observational basis for EZ parameterization in numerical models.

28 September 2023 in Atmospheric Measurement Techniques
Verified
Journal Article
Open access
PDF file
LWLonglong Wang
Longlong Wang
ZYZhenping Yin
Zhenping Yin
ZBZhichao Bu
Zhichao Bu
AWAnzhou Wang
Anzhou Wang
SMSong Mao
Song Mao
Xuan WANGXuan WANG
Xuan WANG
Aerosol lidar networks can play an important role in revealing structural characteristics of the atmospheric boundary layer, the urban heat island effect, and the spatial distribution of aerosols, especially in relation to the monitoring of atmospheric pollution in megacities. To fulfill the need of the monitoring and numerical forecasting of atmospheric pollution, an aerosol lidar network is proposed by the China Meteorological Administration which serves as an important part of the “MegaCity Experiment on Integrated Meteorological Observation in China” (MEMO). To ensure a high standard of data quality and traceability of measurement error, an inter-comparison campaign, dedicated to the quality assessment of lidar systems from different institutes and manufacturers, was designed and performed at Beijing Southern Suburb Observatory in September 2021. Six Mie–Rayleigh lidar systems at 1064 nm were involved in this campaign. The strategies for lidar self-evaluations and inter-comparisons were predefined. A lidar system at 1064 nm, which was developed by the Atmospheric Remote Sensing group at Wuhan University, was selected as the reference lidar system after passing all strict self-evaluation quality checks. The reference lidar system serves as the cornerstone for evaluating the performance of other lidar systems. After using the Rayleigh fit and signal-to-noise evaluation self-tests for each individual lidar system as a fast check of the data quality, the range-corrected signal and backscatter coefficient obtained from all the lidar systems were inter-compared with a reference lidar system. In the end, the lidar systems passed the quality control/assurance, ensuring that the standard deviation of range-corrected signal could be controlled within 5 % at 500–2000 m and 10 % at 2000–5000 m. For the derived aerosol backscatter coefficients, standard deviations can be controlled within 10 % at 500–2000 and 2000–5000 m. The quality assurance strategy lays down a solid basis for atmospheric lidar at near-infrared wavelengths and will be applied in Chinese lidar network development.