Iron Hopping: Iron oxide minerals shuttle electrons around in a wide range of biogeochemical processes.
Katz
et al. (p. 1200 ) used time-resolved x-ray absorption spectroscopy to take a closer look at how this happens. By using photoionized surface dyes to inject electrons into three different solid oxide phases, they found that electrons hop among iron centers at rates that depend more on structure in their immediate vicinity than on the extended ordering of the crystal lattice. These observations bolster the prevailing small polaron model in which charge carriers associate closely with individual metal sites.
1 December 2010 in The Journal of Physical Chemistry C
The effects of compositionally induced changes on the semiconducting properties, optical response, chemical stability, and overall performance of photoanodes in photoelectrochemical (PEC) cells have been investigated. Single crystals of n-type Ca- and Ba-doped with carrier concentrations ranging from were grown and characterized as photoanodes in basic aqueous electrolyte PEC cells. The PEC properties of the crystals, including the photocurrent, photovoltage, and flatband potential in contact with NaOH(aq) were relatively independent of whether Ca or Ba was used to produce the semiconducting form of . All of the Ca- or Ba-doped single-crystal photoanodes were chemically stable in the electrolyte and, based on the open-circuit potential and the band-edge positions, were capable of unassisted photochemical and evolution from . The minority-carrier diffusion lengths values were small and comparable to the depletion region width. Photoanodic currents were only observed for photoanode illumination with light above the bandgap (i.e., ). The maximum external quantum yield occurred at , and the depletion width plus the minority-carrier diffusion length ranged from for the various -based photoanode materials.
13 April 2010 in The Journal of Physical Chemistry Letters
An emerging area in chemical science is the study of solid-phase redox reactions using ultrafast time-resolved spectroscopy. We have used molecules of the photoactive dye 2′,7′-dichlorofluorescein (DCF) anchored to the surface of iron(III) oxide nanoparticles to create iron(II) surface atoms via photo-initiated interfacial electron transfer. This approach enables time-resolved study of the fate and mobility of electrons within the solid phase. However, complete analysis of the ultrafast processes following dye photoexcitation of the sensitized iron(III) oxide nanoparticles has not been reported. We addressed this topic by performing femtosecond transient absorption (TA) measurements of aqueous suspensions of uncoated and DCF-sensitized iron oxide and oxyhydroxide nanoparticles, and an aqueous iron(III)–dye complex. Following light absorption, excited state relaxation times of the dye of 115–310 fs were found for all samples. Comparison between TA dynamics on uncoated and dye-sensitized hematite nanoparticles revealed the dye de-excitation pathway to consist of a competition between electron and energy transfer to the nanoparticles. We analyzed the TA data for hematite nanoparticles using a four-state model of the dye-sensitized system, finding electron and energy transfer to occur on the same ultrafast timescale. The interfacial electron transfer rates for iron oxides are very close to those previously reported for DCF-sensitized titanium dioxide (for which dye–oxide energy transfer is energetically forbidden) even though the acceptor states are different. Comparison of the alignment of the excited states of the dye and the unoccupied states of these oxides showed that the dye injects into acceptor states of different symmetry (Ti t2gvs. Fe eg).