1 October 2021 in Science
Far away landslide detection: A mass wasting and flood event on 7 February 2021 in Uttarakhand, India, killed more than 200 people and damaged two hydropower plants. Cook et al . discovered that teleseimic signals from the beginning of this event were recorded at different stations on a regional seismic network in northern India. The signals were observed up to 100 kilometers from the disaster and demonstrate the potential for these far-away monitoring stations to be useful for early warning. This discovery suggests a different way to monitor such remote Himalayan valleys for mass wasting hazards. —BG
1 May 2019 in Earthquake Spectra
The one‐dimensional (1‐D) approach is still the dominant method to incorporate site effects in engineering applications. To bridge the 1‐D to multidimensional site response analysis, we develop quantitative criteria and a reproducible method to identify KiK‐net sites with significant deviations from 1‐D behavior. We found that 158 out of 354 show two‐dimensional (2‐D) and three‐dimensional (3‐D) effects, extending the resonance toward shorter periods at which 2‐D or 3‐D site effects exceed those of the classic 1‐D configurations and imposing an additional amplification to that caused by the impedance contrast alone. Such 2‐D and 3‐D effects go along with a large within‐station ground motion variability. Remarkably, these effects are found to be more pronounced for small impedance contrasts. While it is hardly possible to identify common features in ground motion behavior for stations with similar topography typologies, it is not over‐conservative to apply a safety factor to account for 2‐D and 3‐D site effects in ground motion modeling.
1 August 2009 in Geophysical Journal International
9 December 2014 in Bulletin of Engineering Geology and the Environment
1 May 2022 in Earthquake Spectra
Earthquake site responses or site effects are the modifications of surface geology to seismic waves. How well can we predict the site effects (average over many earthquakes) at individual sites so far? To address this question, we tested and compared the effectiveness of different estimation techniques in predicting the outcrop Fourier site responses separated using the general inversion technique (GIT) from recordings. Techniques being evaluated are (a) the empirical correction to the horizontal‐to‐vertical spectral ratio of earthquakes (c‐HVSR), (b) one‐dimensional ground response analysis (GRA), and (c) the square‐root‐impedance (SRI) method (also called the quarter‐wavelength approach). Our results show that c‐HVSR can capture significantly more site‐specific features in site responses than both GRA and SRI in the aggregate, especially at relatively high frequencies. c‐HVSR achieves a “good match” in spectral shape at ∼80%–90% of 145 testing sites, whereas GRA and SRI fail at most sites. GRA and SRI results have a high level of parametric and/or modeling errors which can be constrained, to some extent, by collecting on‐site recordings.
19 April 2022 in Journal of Seismology
Microtremor array measurements, and passive surface wave methods in general, have been increasingly used to non-invasively estimate shear-wave velocity structures for various purposes. The methods estimate dispersion curves and invert them for retrieving S-wave velocity profiles. This paper summarizes principles, limitations, data collection, and processing methods. It intends to enable students and practitioners to understand the principles needed to plan a microtremor array investigation, record and process the data, and evaluate the quality of investigation result. The paper focuses on the spatial autocorrelation processing method among microtremor array processing methods because of its relatively simple calculation and stable applicability.Highlights: 1. A summary of fundamental principles of calculating phase velocity from ambient noise2. General recommendations for MAM data collection and processing using SPAC methods3. A discussion of limitations and uncertainties in the methods