1 June 2018 in Emerging Materials Research
Gum acacia (GA) is a natural gum with a high molecular weight; it is a polysaccharide material that is acidic in nature and the least viscous among hydrocolloids. The ion-conducting behavior of water-dissolvable GA-based gel electrolytes has been studied with salt (ammonium chloride (NH4Cl)) concentration, GA content and temperature enhancement. The conductivity of GA-based gel electrolytes without salt has been found to increase with the increase in GA content at low concentrations and reaches a maximum value of 4·99 × 10−3 S/cm at 40 wt.% of GA and then shows a small decrease at higher concentrations of GA. GA-based gel electrolytes show ionic conductivity decrements and indicate negative activation energy with increase in temperature, which contradicts the theoretical explanation – that is, σ = σ o exp(−E a/K b T). An ionic conductivity on the order of 10−1 S/cm has been observed for varying weights percentages of GA-based gel electrolytes containing 5 M ammonium chloride and does not show much change with temperature enhancement from 10 to 70°C, which makes it suitable for their use in fuel cells and other device applications.
1 September 2018 in Surface Innovations
A cost-effective drop-cast technique has been used to deposit copper phthalocyanine (CuPc) films on a glass substrate. The obtained films have undergone structural, optical and electrical characterization after annealing at different temperatures – that is, 100, 150 and 200°C. The X-ray diffraction spectra confirm the formation of CuPc films. The absorption spectra of the drop-cast CuPc films show two dominant bands – Q-band and Soret band – within wavelengths of 300–800 nm, respectively. Phase transformations from the α-phase to β-phase have been observed from structural and optical characterization. The current–voltage parameters of the films show ohmic contact, and their activation energies lie in the range of 0·21–0·54 eV annealed within temperatures of 100–200°C. The vapor-sensing characteristics of the CuPc-based sensor toward ammonia at different concentrations (15–230 parts per million) have been evaluated. These measurements reveal that CuPc films are a good candidate as ammonia sensors.
1 July 2018 in Surface Innovations