Static jar test and dynamic loop are two major test methods used for study of mineral scale formation and evaluation of scale inhibitors. In both methods, the flow is generally in the regime of laminar condition, which may not be representative of turbulent flow under field conditions. Turbulent flow in oilfield pipes is very common, especially around chokes, tubing joints, and safety values. The objective of this study is to investigate mineral scale formation and control under turbulent conditions. A novel testing method of rotating cylinder apparatus has been developed for turbulent conditions. In rotating cylinder experiments, highly turbulent flow (up to a Reynolds number of 11,000) was created by a rotating cylinder under field temperature of 70 °C. Barite scale formation and inhibition by several typical inhibitors were investigated under different flow conditions. During the experiments, barium concentration was measured periodically to determine scale kinetics. Barite precipitate was collected at the end of the experiment and examined by scanning electron microscope (SEM). Experimental results show no significant difference in precipitation kinetics between laminar and turbulent flow without scale inhibitors. However in the presence of scale inhibitors, precipitation kinetics was slower under high turbulence. SEM images also display major difference in barite size and morphology between different flow conditions. Highly crystalline barite with an average size of 10 µm was found in laminar flow, whereas amorphous or poorly crystalline barite of only sub micrometers was formed in turbulent flow. These results indicate that scale inhibitors may be more effective under some turbulent conditions, as opposed to previous observations. The insights presented in this work will help to understand scale control in oilfield pipes especially under turbulent conditions, and develop optimal doses of scale inhibitors with regard to flow regimes.
Steamflooding has been used as one of the emerging techniques to enhance heavy oil production. Scale control during steamflooding, on the other hand, can be challenging since the high temperature of the steamflood can decompose thermally unstable inhibitors and/or lead to the precipitation of metal-inhibitor pseudo-scale. In this paper, we present the analysis of the scaling risk and scale inhibition for a pilot steamflood project in a Middle Eastern oilfield. The formation of this field is a dolomite formation interbedded with anhydrite (CaSO4) streaks. Anhydrite has been observed to be the predominant scale form, which is presumably formed due to increased production system temperature as a result of steamflooding and/or mixing of steam condensate with incompatible connate water. Anhydrite is inherently difficult to control due to its high solubility and the high temperature conditions under which it forms. Compared to barite and carbonate, only limited knowledge has been acquired for anhydrite control. To predict the scaling tendency and inhibitor need in different wells of this field with different supersaturation level and temperature, a scaling risk model has been developed. To build such a model, detailed and revised laboratory procedures have been developed to study nucleation and precipitation kinetics of anhydrite at 125-175 ºC, different supersaturation, water composition, and long reaction time. Predictions of this scaling risk model suggest a saturation index (SI) of 0.8 as a critical SI for anhydrite control at >125 ºC. For example, when the SI is above 0.8, anhydrite will be difficult to control in the presence of threshold inhibitor. Model predictions were found to be consistent with scale occurrence observations in different wells of this field. With the recommended inhibitor concentrations, anhydrite scale has been controlled in this field, which provides validation that the proposed scaling risk model is a powerful tool to optimize scale treatment plan.