A wetland's ability to vertically accrete—capturing sediment and biological matter for soil accumulation—is key for maintaining elevation to counter soil subsidence and sea level rise. Wetland soil accretion is comprised of organic and inorganic components largely governed by net primary productivity and sedimentation. Sea level, land elevation, primary productivity, and sediment accretion are all changing across Louisiana's coastline, destabilizing much of its wetland ecosystems. In coastal Louisiana, analysis from 1984 to 2020 shows an estimated 1940.858 km2 of total loss at an average rate of 53.913 km2/year. Here we hypothesize that remote sensing timeseries data can provide suitable proxies for organic and inorganic accretionary components to estimate local accretion rates. The Landsat catalog offers decades of imagery applicable to tracking land extent changes across coastal Louisiana. This dataset's expansiveness allows it to be combined with the Coastwide Reference Monitoring System's point‐based accretion data. We exported normalized difference vegetation index (NDVI) and red‐band surface reflectance data for every available Landsat 4–8 scene across the coast using Google Earth Engine. Water pixels from the red‐band were transformed into estimates of total suspended solids to represent sediment deposition—the inorganic accretionary component. NDVI values over land pixels were used to estimate bioproductivity—representing accretion's organic component. We then developed a Random Forest regression model that predicts wetland accretion rates (R2 = 0.586, MAE = 0.333 cm/year). This model can inform wetland vulnerability assessments and loss predictions, and is to our knowledge the first remote sensing‐based model that directly estimates accretion rates in coastal wetlands.
26 January 2022 in Earth Surface Processes and Landforms
Coastal marsh survival relies on the ability to increase elevation and offset sea level rise. It is therefore important to realistically model sediment fluxes between marshes, tidal channels, and bays as sediment availability controls accretion. Traditionally, numerical models have been calibrated and validated using in situ measurements at a few locations within the domain of interest. These datasets typically provide temporal information but lack spatial variability. This paper explores the potential of coupling numerical models with high-resolution remote sensing imagery. Products from three sensors from the NASA Delta-X airborne mission are used. Uninhabited Aerial Vehicle Synthetic Aperture Radar (UAVSAR) provides vertical water level change on the marshland and was used to adjust the bathymetry and calibrate water fluxes over the marsh. AirSWOT yields water surface elevation within bays, lakes, and channels, and was used to calibrate the Chezy bottom friction coefficient. Finally, imagery from AVIRIS-NG provides maps of total suspended solids (TSS) concentration that were used to calibrate sediment parameters of settling velocity and critical shear stress for erosion. Three numerical models were developed at different locations along coastal Louisiana using Delft3D. The coupling enabled a spatial evaluation of model performance that was not possible using simple point measurements. Overall, the study shows that calibration of numerical models and their general performance will greatly benefit from remote sensing.
26 February 2024 in Journal of Geophysical Research: Earth Surface
Predicting the freezing time in lakes is achieved by means of complex mechanistic models or by simplified statistical regressions considering integral quantities. Here, we propose a minimal model (SELF) built on sound physical grounds that focuses on the pre-freezing period that goes from mixed conditions (lake temperature at 4 ∘C) to the formation of ice (0 ∘C at the surface) in dimictic lakes. The model is based on the energy balance involving the two main processes governing the inverse stratification dynamics: cooling of water due to heat loss and wind-driven mixing of the surface layer. They play opposite roles in determining the time required for ice formation and contribute to the large interannual variability observed in ice phenology. More intense cooling does indeed accelerate the rate of decrease of lake surface water temperature (LSWT), while stronger wind deepens the surface layer, increasing the heat capacity and thus reducing the rate of decrease of LSWT. A statistical characterization of the process is obtained with a Monte Carlo simulation considering random sequences of the energy fluxes. The results, interpreted through an approximate analytical solution of the minimal model, elucidate the general tendency of the system, suggesting a power law dependence of the pre-freezing duration on the energy fluxes. This simple yet physically based model is characterized by a single calibration parameter, the efficiency of the wind energy transfer to the change of potential energy in the lake. Thus, SELF can be used as a prognostic tool for the phenology of lake freezing.