18 April 2015 in Advanced Robotics
3 July 2015 in Fire Technology
1 September 2015 in Engineering Science and Technology, an International Journal
The environmental and economic merits of converting solar energy into electricity via photovoltaic cells have led to its enormous growth in this sector. Besides material and design parameters, there are many other factors which locally affect Photovoltaic cell like partial shading, humidity, dust, bird droppings, air velocity etc. However, the effect due to a single solar photo voltaic cell being connected to a serial or parallel network (to form a grid) has never been deliberated extensively. In this paper a system design that will detect the underperforming panel in the entire grid is proposed and validated. All the Photo voltaic panels in a grid are connected with current sensors, which are connected to microcontrollers and these microcontrollers are locally connected with the wireless sensor network. With the help of wireless sensor network, grid monitoring for individual panel has been achieved for the first time with proposed system. The grid and control room is also connected wirelessly which enables the engineer monitoring the grid to meticulously locate the individual solar photovoltaic cell which is underachieving and solve the issue pertaining the same. The proposed system design has been validated with the help of data obtained with Centre for Wind Energy Technology (CWET), Govt. of India.”
1 January 2015 in Procedia Computer Science
Photovoltaic module working temperature significantly reduces the electrical efficiency, increases degradation rates and thermal stresses. In solar module operation temperature is an important issue. As with appropriate cooling system, electrical output can be increased, a special pass reverse flow absorber collector is designed and developed. And a commercial polycrystalline module is modified by gluing this heat extraction unit by thermally conducted epoxy at back surface of module through which water is flowing by gravity at preset flow rate and no pump is used. Electrical and thermal performance of modified system has been evaluated for climatic condition of Dehradun in comparison with reference module. From collected real time data cooling coefficients of electrical parameters of modified proposed module with respect to reference are derived by mathematical modelling and programming in MATLAB at optimized flow rate for minimum operating temperature. It is found that there is significant increase in electrical efficiency. The effect of environmental parameters on cooling coefficients is also analyzed. RS232 logic and MATLAB GUI are used to log the real time electrical and environmental parameters
28 October 2015 in Archive of Applied Mechanics
1 January 2014 in IFAC Proceedings Volumes