This article presents a machine learning approach to tungsten spectroscopy analysis using measurements performed in WEST tokamak plasmas. We developed a Random Forest algorithm to predict the maximum electron temperature (Temax) based on 45–65 Å tungsten brightness spectra measured along a mobile line of sight. The model achieves prediction errors typically below 5% across a broad temperature range (0.5–4 keV). Feature importance analysis highlights both physically meaningful wavelengths and others that, despite lacking direct interpretability, improve prediction stability and accuracy. In addition, a principal component analysis is conducted to investigate the relation between spectral variance and Temax unraveling that unaccounted-for parameters influence the spectral shape. Combined with the wavelength importance analysis, this study could potentially inform atomic structure and collisional-radiative models to better understand the tungsten spectral emission.
We present and discuss systematic collisional-radiative calculations of tungsten plasmas at an electron density of about 5×1013 cm−3 and for temperatures in the range 50 eV–30 keV, a range relevant to the operation of fusion reactors. The calculations are based on state-of-the-art configuration average methods that include essential results of the unresolved transition array theory. Among our main results are the mean ionization, charge state distribution, broadband emissivity, and the cooling factor of tungsten. Some of these data are compared with previous predictions. The differences are noticeable, and a tentative discussion of these is presented throughout the article. Our results remain consistent with existing experimental results.
Understanding the performance of limiter plasmas in the ITER start-up phase is important for the whole pulse and a possible challenge if performed on tungsten, as will now be the case following the switch to a W first wall in the new 2024 ITER Baseline. Experiments were performed on ASDEX Upgrade and WEST to characterise limiter plasmas using boronizations with different degree of boron surface coverage and toroidal asymmetries. Non-boronized start-up is shown to be slow and laborious, and, on both machines, was aborted in favor of a non-homogeneous boronization, performed also in support of the ITER re-baseline to study the impact of spatially non-uniform boron coatings. This allows normal start-up and short (few 100 m s , ITER will run s long limiter phases) limiter phases can be run without problems. Even with a full boronization, the limiter can de-condition and long limiter plasmas of several seconds suffer from high densities and radiation. Short limiter plasmas for plasma current ramp-up remain possible. The conditioning effect on limiter plasmas is documented, but also how the start-up is affected by an ageing boronization.
20 April 2026 in Plasma Physics and Controlled Fusion
Understanding ion temperature dynamics is crucial for interpreting energy transport, heating and confinement in magnetically confined plasmas. In the WEST tokamak, ion temperature is typically inferred from neutron flux measurements, which provide reliable global estimates but lack spatial resolution. To overcome this limitation, we employ the X-ray Imaging Crystal Spectrometer (XICS), which allows ion temperature measurements with both temporal and spatial resolution. This paper presents the XICS diagnostic, methods, its capabilities and limitations. As an illustration an analysis of two representative WEST discharges are presented. The first features stationary plasma parameters, highlighting the temporal and spatial evolution of ion temperature profiles along with associated uncertainties. The second involves an X-Point Radiator (XPR) regime, where a sudden increase in ion temperature and profile modification are observed. A comparison with neutron flux measurements demonstrates good agreement, confirming the reliability of XICS and its potential for future experimental campaigns.