Utilization of remote sensing is a new wave of modern agriculture that accelerates plant breeding and research, and the performance of farming practices and farm management. High-throughput phenotyping is a key advanced agricultural technology and has been rapidly adopted in plant research. However, technology adoption is not easy due to cost limitations in academia. This article reviews various commercial unmanned aerial vehicle (UAV) platforms as a high-throughput phenotyping technology for plant breeding. It compares known commercial UAV platforms that are cost-effective and manageable in field settings and demonstrates a general workflow for high-throughput phenotyping, including data analysis. The authors expect this article to create opportunities for academics to access new technologies and utilize the information for their research and breeding programs in more workable ways.

Roots are the most important plant organ for absorbing essential elements, such as water and nutrients for living. To develop new climate-resilient soybean cultivars, it is essential to know the variation in root morphological traits (RMT) among diverse soybean for selecting superior root attribute genotypes. However, information on root morphological characteristics is poorly understood due to difficulty in root data collection and visualization. Thus, to overcome this problem in root research, we used a 2-dimensional (2D) root image in identifying RMT among diverse soybeans in this research. We assessed RMT in the vegetative growth stage (V2) of 372 soybean cultivars propagated in polyvinyl chloride pipes. The phenotypic investigation revealed significant variability among the 372 soybean cultivars for RMT. In particular, RMT such as the average diameter (AD), surface area (SA), link average length (LAL), and link average diameter (LAD) showed significant variability. On the contrary RMT, as with total length (TL) and link average branching angle (LABA), did not show differences. Furthermore, in the distribution analysis, normal distribution was observed for all RMT; at the same time, difference was observed in the distribution curve depending on individual RMT. Thus, based on overall RMT analysis values, the top 5% and bottom 5% ranked genotypes were selected. Furthermore, genotypes that showed most consistent for overall RMT have ranked accordingly. This ultimately helps to identify four genotypes (IT 16538, IT 199127, IT 165432, IT 165282) ranked in the highest 5%, whereas nine genotypes (IT 23305, IT 208266, IT 165208, IT 156289, IT 165405, IT 165019, IT 165839, IT 203565, IT 181034) ranked in the lowest 5% for RMT. Moreover, principal component analysis clustered cultivar 2, cultivar 160, and cultivar 274 into one group with high RMT values, and cultivar 335, cultivar 40, and cultivar 249 with low RMT values. The RMT correlation results revealed significantly positive TL and AD correlations with SA (r = 0.96) and LAD (r = 0.85), respectively. However, negative correlations (r = −0.43) were observed between TL and AD. Similarly, AD showed a negative correlation (r = −0.22) with SA. Thus, this result suggests that TL is a more vital factor than AD for determining SA compositions.

Kenaf (Hibiscus cannabinus L.) is widely used as an important industrial crop. It has the potential to act as a sustainable energy provider in the future, and contains beneficial compounds for medical and therapeutic use. However, there are no clear breeding strategies to increase its biomass or leaf volume. Thus, to attain an increase in these parameters, we examined potential key traits such as stem diameter, plant height, and number of nodes to determine the relationship among them. We hypothesized that it would be easier to reduce the amount of time and labor required for breeding if correlations among these parameters are identified. In this study, we found a strong positive correlation between height and number of nodes (Spearman’s Rho = 0.67, p < 0.001) and number of nodes and stem diameter (Spearman’s Rho = 0.65, p < 0.001), but a relatively low correlation (Spearman’s Rho = 0.34, p < 0.01) between height and stem diameter in the later stages of kenaf growth. We suggest that an efficient breeding strategy could be devised according to the breeding purpose, considering the correlations between various individual traits of kenaf.